A.pleting aggressive implementation schedule
B.Stateful Switchover
C.pany and user expectations
D.Nonstop Forwarding
E.change control processes
F.dual devices and dual links
您可能感興趣的試卷
你可能感興趣的試題
A.jitter
B.delay
C.PoE
D.bandwidth
E.packet loss
During voice implementation，
which two required items are configured at an access layer switch connected to an IP phone to provide VoIP communication？（）
A.allowed codecs
B.native VLAN
C.auxiliary VLAN
D.Cisco Unified Communications Manager IP address
E.RSTP
A network is deployed using best practices of the enterprise campus network model， including users with desktop computers connected via IP phones. Given that all components are QoS-capable，
where are the two optimal locations for trust boundaries to be configured by the network administrator？（）
A.host
B.IP phone
C.access layer switch
D.distribution layer switch
E.core layer switch
Wireless has been operating correctly in the campus infrastructure. After the wireless controllers are upgraded from LWAPP to CAPWAP， access points no longer boot and operate normally.
What is the most likely issue causing this problem？（）
A.VLAN assignments
B.DHCP option 43
C.PoE
D.ACL
E.QoS
A standalone wireless AP solution is being installed into the campus infrastructure. The access points appear to boot correctly， however， wireless clients are not obtaining correct access. You verify that the local switch configuration connected to the access point appears as the following：
interface ethernet 0/1
switchport access vlan 10
switchport mode access
spanning-tree portfast
mls qos trust dscp
What is the most likely issue causing the problem？（）
A.QoS trust should not be configured on a port attached to a standalone AP.
B.QoS trust for switchport mode access should be defined as "cos".
C.switchport mode should be defined as "trunk" with respective QoS.
D.switchport access vlan should be defined as "1".
最新試題
Refer to the exhibit. Switch 15 is configured as the root switch for VLAN 10 but not for VLAN 20. If the STP configuration is correct， what will be true about Switch 15？（）
Refer to the exhibit. The command switchport mode access is issued on interface FastEthernet0/13 on switch CAT1. What will be the result？（）
How are STP timers and state transitions affected when a topology change occurs in an STP environment？（）
Based on the show spanning-tree vlan 200 output shown in the exhibit， which two statements about the STP process for VLAN 200 are true？ （）
Refer to the exhibit. Initially， LinkA is connected and forwarding traffic. A new LinkB is then attached between SwitchA and HubA. Which two statements are true about the possible result of attaching the second link？（）
Which router redundancy protocol cannot be configured for interface tracking？（）
Refer to the exhibit. STP has been implemented in the network. Switch SW_A is the root switch for the default VLAN. To reduce the broadcast domain， the network administrator decides to split users on the network into VLAN 2 and VLAN 10. The administrator issues the command spanning-tree vlan 2 root primary on switch SW_A. What will happen as a result of this change？（）
What will occur when a nonedge switch port that is configured for Rapid Spanning Tree does not receive a BPDU from its neighbor for three consecutive hello time intervals？（）
DS2 has not become the active device for Vlan103’s HSRP group even though all interfaces are active. As related to Vlan103’s HSRP group. What can be done to make the group function properly ？ （）
Refer to the exhibit and the partial configuration of switch SW_A and SW_B. STP is configured on all switches in the network. SW_B receives this error message on the console port：00：06：34： %CDP-4-DUPLEX_MISMATCH： duplex mismatch discovered on FastEthernet0/5 （not half duplex）， with SW_A FastEthernet0/4 （half duplex） ， with TBA05071417（Cat6K-B） 0/4 （half duplex）. What would be the possible outcome of the problem？（）