A.increase the flow of the cooling water through the condenser
B.adjust the high pressure cutout to maintain the desired pressure
C.open the hot gas bypass temporarily to reduce capacity
D.purge non-condensable gases to reduce the excess pressure
您可能感興趣的試卷
你可能感興趣的試題
A.Special tools are required for lapping or grinding
B.It is impossible to throttle flow with a butterfly valve
C.To close the valve, it is only necessary to turn the handle a quarter of a turn
D.The butterfly valve should never be used in a freshwater system
A.closely observe the pump discharge temperature
B.close off the discharge valve, and watch for a rise in pressure
C.momentarily close off the suction valve, and watch for a rise in pressure
D.use a clamp on ammeter and compare the readings to past records
A.removing all but the frictional load during starting
B.relieving intercoolers of high temperature buildups
C.providing high starting torque in the drive motor
D.seating valve plates during compressor shutdown
A.loose expansion valve control bulb
B.low differential setting on the H-Pcutout
C.blown fuse in the motor circuit
D.faulty suction pressure regulator
A.prevent an internal explosion in the pump when it is overheated
B.enable a visual inspection of the pump while it is running
C.insure a proper alignment of the pump coupling to the driver
D.accommodate for friction between the impeller and the easing
最新試題
The usual symptoms of cavitation in a centrifugal pump is （）.
The general purpose of a heat exchanger is to （）.
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will （）.
Thermostatic expansion valves can be adjusted for （）.
When a refrigeration compressor has developed a high head pressure as a result of a refrigerant overcharge, you should （）.
An excessive charge of refrigerant in an air-cooled refrigeration system can cause （）.
If the viscosity of the liquid being transferred remains constant as the discharge pressure increases, the rotary pump （）.
If the suction pressure at the refrigeration compressor is below normal, the cause can be（）.
When the steering gear is in operation, you should （）.
Pitting in the suction areas of a centrifugal pump bronze impeller is usually caused by （）.