A.psk authentication
B.eap authentication
C.wpa authentication
D.web authentication
您可能感興趣的試卷
你可能感興趣的試題
Vlans have been enabled on an autonomous access point. in order for clients associating to vlans other than the native vlan to receive an ip address.
Which of the following must be configured？（）
A.access point ethernet port set to ssl trunking
B.switchport set to 802.1q trunking
C.switchport set to ssl trunking
D.access point ethernet port not set to 802.1q trunking
A.controller name
B.outdoor area
C.floor area
D.networks
E.mac address
F.ip address
A.router （config）# wlccp authentication-server infrastructure eap group_1
B.router （config）# wlccp authentication-server infrastructure eap-fast group_1
C.router （config）# wlccp authentication-server client eap-fast group_1
D.router （config）# wlccp authentication-server client eap group_1
A.registration error
B.authentication failures threshold
C.http disabled
D.telnet disabled
A.administrators
B.system monitoring
C.network operator
D.power users
E.admin
F.users’ assistant
最新試題
On a WLAN controller， what is the default roaming bandwidth percentage reserved for voice clients？（）
You have just finished aligning a Cisco Aironet 1400 Series Wireless Bridge link using installationmode. When you set the link back to operational mode you loose association to the root bridge.Which action will correct the problem？（）
You are installing a Cisco Aironet 1000 Series controller-based access point. When you boot it， allthe LEDs on the access point blink together.What does this indicate about the access point？（）
The IOS of a North American Cisco Aironet 1130AG Series standalone access point has becomecorrupt. You must therefore reload the TFTP firmware.Before you press and hold the MODEbutton， you should verify that the file name is which of the following？（）
Which of the following commands on the wireless interface of a Cisco 3845 Integrated Service Router allows the SSID to broadcast？（）
You want to dynamically assign users to an 802.1Q VLAN as a result of their authentication. Inorder to accomplish this.Which two IETF RADIUS attributes should you configure on the CiscoSecure ACS？ （）
An REAP was supporting 16 WLANs， but now it only supports one.What happened to cause the change？（）
When configuring Cisco Secure ACS to support wireless EAP authentication， which device must be configured as a AAA client？（）
A Cisco WCS version 4.0 has been installed on a server with a dual Pentium 3.0 GHz processor，4GB RAM， and an 80 GB hard drive. A location appliance has been incorporated into the networkand is being monitored by the Cisco WCS. There are 3000 devices to be tracked but not all of themare being tracked on the Cisco WCS.What can be done to correct the problem？（）
You are installing a Cisco 4402 Series Wireless LAN Controller.What type of interface is used on the uplink port？（）