A.router （config）# wlccp authentication-server infrastructure eap group_1
B.router （config）# wlccp authentication-server infrastructure eap-fast group_1
C.router （config）# wlccp authentication-server client eap-fast group_1
D.router （config）# wlccp authentication-server client eap group_1
您可能感興趣的試卷
你可能感興趣的試題
A.registration error
B.authentication failures threshold
C.http disabled
D.telnet disabled
A.administrators
B.system monitoring
C.network operator
D.power users
E.admin
F.users’ assistant
When configuring vlans on an autonomous access point.
What must be configured on the connected switchport？（）
A.802.1q trunking
B.vtp trunking
C.isl trunking
D.dpt trunking
There are 30 managed access points on the wlse. a radio scan is started but fails. Upon
inspection of the device list in the reports tab， you notice a red indicator on the wds access point. upon inspection of the wds access point through its guid， it is discovered that the security keys are not set up between the wds access point and the wlse.
Which of the following is mis configured？（）
A.snmp communities
B.telnet/ssh user/password
C.wlccp credentials
D.http user/password
You are using adu and are authenticated and associated to an access point. you are unable to obtain an ip address.
Which of the following will cause this problem？（）
A.aes encryption enabled
B.tkip enabled
C.third-party wireless supplicant enabled
D.802.1x authentication type enabled
最新試題
You have just finished aligning a Cisco Aironet 1400 Series Wireless Bridge link using installationmode. When you set the link back to operational mode you loose association to the root bridge.Which action will correct the problem？（）
A client roams from H-REAP AP1 to H-REAP AP2. The client is unable to associate to H-REAP AP2.H-REAP AP2 has six other clients associated to it， which continue to pass traffic.What has causedthis problem？（）
You have been called upon to add location-based services into an existing controller-basedwireless design which primarily encompasses handheld devices such as barcode scanners and Cisco7920 wireless IP phones.In which mode should you deploy the additional access points to achievethe density required without excessive co-channel interference？（）
You are installing a Cisco Aironet 1000 Series controller-based access point. When you boot it， allthe LEDs on the access point blink together.What does this indicate about the access point？（）
You want to dynamically assign users to an 802.1Q VLAN as a result of their authentication. Inorder to accomplish this.Which two IETF RADIUS attributes should you configure on the CiscoSecure ACS？ （）
A mobility group is created by a Cisco WLCM and 4402 Series Wireless LAN Controller. A client thatis anchored on the Cisco WLCM roams to an access point on the 4402 controller. You then run adebug command on the 4402 controller.Which message would best describe the establishment ofthe tunnel from the foreign controller’s perspective？（）
On a Cisco Aironet 1240AG Series standalone access point， the radio LED is dark blue and blinking，but the status LED and Ethernet LED are both off.What does this indicate？（）
An REAP was supporting 16 WLANs， but now it only supports one.What happened to cause the change？（）
You are troubleshooting a one-way call problem with a Cisco 7920 wireless IP phone on a standalone WLAN.What may cause this problem？（）
You are using ADU and are authenticated and associated to an access point. However， you are unable to obtain an IP address.Which of these has caused this problem？（）