You work as a network administrator in your company. Communication inside the company is ensured by network environments, such as GET VPN, Dynamic Multipoint VPN and Ethernet.
Which PIN architecture is applicable in those environments?（）
A.Campus
B.Teleworker
C.Branch
D.Data center
您可能感興趣的試卷
你可能感興趣的試題
A. Branch
B. Campus
C. Teleworker
D. Data center
Refer to the exhibit. Which two of these accurately describe this router's supervisor redundancy status? （）(Choose two.)
A. both supervisors are active
B. SSO redundancy is being used
C. the second supervisor is unavailable
D. the primary supervisor is unavailable
E. the primary supervisor was reloaded nine seconds ago
Refer to the exhibit. What is the HSRP state and priority of this interface after HSRP reaches its steady state?（）
A. Active, Priority 151
B. Active, Priority 201
C. Active, Priority 251
D. Standby, Priority 151
E. Standby, Priority 201
F. Standby, Priority 251
HSRP. Known as Hot Stanclby Router Protocol, is a Cisco proprietarv redundancy protocol . As an experienced network administrator, you are required to configure HSRP on a XYZ network.
Which TWO of the following wii be available and shared between the routers configured with HSRP? （）(Choose two.)
A. a shared single interface
B. the ability to track serial interfaces
C. UDP-based hello packets
D. the impact of flapping links if timers are too low
A. It is achieved by using more than one HSRP group.
B. It is done in regards to either round robin or weight basis.
C. It is used to offload the active router in a certain HSRP group.
D. The return traffic is influenced by HSRP load sharing configuration.
E. Single group HSRP is used to achieve more efficient link utilization.
最新試題
Refer to the exhibit. Analyze the two traceroutes that are displayed. Which of these statements is correct in describing what most likely caused the traceroute differences?（）
Which command is used to view IPv6 parameters related to the BGP process?（）
Which configuration will enable OSPF for IPv6 on FastEthernet 0/0/0?（）
Refer to the exhibit. Which two of these statements are correct? (Choose two.)（）
In a high-availability network, which command, when placed on ports that have connected end stations, will allow you to prevent delays in service for end stations by placing a port in blocking mode?（）
Refer to the exhibit. You have a non-Cisco switch that is not communicating properly while connected to the distribution-layer Cisco switching fabric.Which two best-practice actions can you take to overcome this problem? （）(Choose two.)
Which keyword is used with the debug ipv6 [keyword] command to troubleshoot neighbor discovery problems?（）
You are trying to initiate an SSH connection to a remote router and are getting rejected with an error code of 0. Which of these might be the cause of the error?（）
Refer to the exhibit. You want to minimize the downtime that results from supervisor engine switchovers on Cisco 6500 Series Switches and Cisco 7600 Series Routers. To achieve this, you are considering deploying a Cisco Nonstop Forwarding with Stateful Switchover solution using OSPF.In the exhibit you can see the output of the show ip ospf neighbor detail command.Which trait of systems using Cisco Nonstop Forwarding with Stateful Switchover and OSPF is shown in the exhibit output and will impact your plan?（）
Which description is making sense on the basis of the given information?（）