多項選擇題

Refer to the exhibit. You have a non-Cisco switch that is not communicating properly while connected to the distribution-layer Cisco switching fabric.
Which two best-practice actions can you take to overcome this problem? ()(Choose two.)

A. Turn off MST (802.1s) on all switches.
B. Turn on MST (802.1s) on all switches.
C. Turn on RSTP (802.1w) on all switches.
D. Turn off RSTP (802.1w) on all switches.


您可能感興趣的試卷

你可能感興趣的試題

1.多項選擇題

Refer to the exhibit. Which two of these statements are correct? (Choose two.)()

A. PE11 originated label 20.
B. PE11 originated label 21.
C. ThePE11 upstream neighbor originated label 21.
D. The PE11 downstream neighbor originated label 20.
E. PE11 will append label 21 to incoming packets labeled 32.
F. PE11 will impose label 20 on incoming packets labeled 32.

2.單項選擇題

Refer to the exhibit. You want to minimize the downtime that results from supervisor engine switchovers on Cisco 6500 Series Switches and Cisco 7600 Series Routers. To achieve this, you are considering deploying a Cisco Nonstop Forwarding with Stateful Switchover solution using OSPF.
In the exhibit you can see the output of the show ip ospf neighbor detail command.
Which trait of systems using Cisco Nonstop Forwarding with Stateful Switchover and OSPF is shown in the exhibit output and will impact your plan?()

A. Stateful Switchover for Cisco Nonstop Forwarding only works with BGP.
B. Stateful Switchover for Cisco Nonstop Forwarding must be configured on all adjacent routers.
C. Cisco Nonstop Forwarding with Stateful Switchover helper mode is not supported on the adjacent router.
D. Cisco Nonstop Forwarding with Stateful Switchover helper mode for OSPF has been promiscuousstandardized and is supported on the adjacent router.

3.多項選擇題

Refer to the exhibit. Which two of these events will be the result of issuing the above command? ()(Choose two.)

A. 64-bit IPv4 prefix will be created.
B. The route distinguisher will be used to indicate VPN membership.
C. Extended BGP communities will be used to encode route distinguishers.
D. A 96-bit VPNv4 prefix will be created and propagated across the IP network. 
E. The route distinguisher is 64 bits and will be prepended to an existing IPv4 route to make it globally unique.

5.單項選擇題With a VPN Accelerator Module 2+ (VAM2+) installed in a Cisco 7200 series router, what will be the resulting action when entering the command no crypto engine accelerator slot number?()

A. disables OIR on the VAM2+ module
B. removes the VAM2+ crypto engine feature and disables the associated configuration commands from the router
C. disables dual VAM2+ hardware stateful failover capabilities
D. disables the crypto engine hardware acceleration, resulting in all crypto functions to be performed in software

最新試題

Refer to the exhibit. Analyze the two traceroutes that are displayed. Which of these statements is correct in describing what most likely caused the traceroute differences?()

題型:單項選擇題

In a high-availability network, which command, when placed on ports that have connected end stations, will allow you to prevent delays in service for end stations by placing a port in blocking mode?()

題型:單項選擇題

Which keyword is used with the debug ipv6 [keyword] command to troubleshoot neighbor discovery problems?()

題型:單項選擇題

Refer to the exhibit. Which two of these events will be the result of issuing the above command? ()(Choose two.)

題型:多項選擇題

As a network administrator, you issue the interface auto qos voip cisco-phone command on a port in an edge network. It is possible for a Cisco Catalyst switch to check if a Cisco IP Phone is directly attached to that port by:()

題型:單項選擇題

Which configuration will enable OSPF for IPv6 on FastEthernet 0/0/0?()

題型:單項選擇題

Refer to the exhibit. Which two of these statements are correct? (Choose two.)()

題型:多項選擇題

What is the purpose of using VPN hardware acceleration equipment?()

題型:單項選擇題

Which Cisco IOS command is used to troubleshoot a problem in which a BGP session stays in the active state?()

題型:單項選擇題

Refer to the exhibit. You have a non-Cisco switch that is not communicating properly while connected to the distribution-layer Cisco switching fabric.Which two best-practice actions can you take to overcome this problem? ()(Choose two.)

題型:多項選擇題