A.ongoing support handoff meeting
B.staff training
C.detailed design development
D.staging and system migration
您可能感興趣的試卷
你可能感興趣的試題
On a standalone access point， client association using eap-cisco wireless （cisco-leap） is failing， but association using eap-peap is functioning.
What needs to be enabled on the standalone access point to correct this issue？（）
A.network eap
B.open authentication plus mac
C.open authentication plus eap
D.a shared key
You have just finished aligning a cisco aironet 1400 series wireless bridge link using
installation mode. when you set the link back to operational mode you loose association to the root bridge.
Which action will correct the problem？（）
A.configure the bridge to force infrastructure devices to associate only to the ssid parameter.
B.enable passwords on both bridges.
C.configure the distance parameter value.
D.configure the proper channel.
A.ssids are not case-sensitive.
B.ssids must be listed in the same order in the adu as they are in the access point.
C.a maximum of three ssids may be configured.
D.ssids may have a maximum of 16 characters.
A.allows client traffic， captures data on all channels
B.allows client traffic， captures data on a single channel
C.allows no client traffic， captures data on all channels
D.allows no client traffic， captures data on a single channel
You are troubleshooting a one-way call problem with a cisco 7920 wireless ip phone on a standalone wlan.
What may have caused this problem？（）
A.the minimum data rate is not set to 11 mbps.
B.publicly secure packet forwarding is enabled.
C.the access point is set to the least congested channel.
D.an address resolution protocol has been disabled.
最新試題
You are charges with implementing a secure wireless installation which will provide Internet accessto client devices but will not allow communications between wireless clients.In addition to implementing PSPF or peer-to-peer blocking on the wireless side，which of the following actionsshould you perform on the wired infrastructure？（）
On a Cisco Aironet 1240AG Series standalone access point， the radio LED is dark blue and blinking，but the status LED and Ethernet LED are both off.What does this indicate？（）
Static WEP is configured on the access point. You are authenticated and associated to the accesspoint but are unable to obtain an IP address.Which of the following will cause this problem？（）
You have just finished aligning a Cisco Aironet 1400 Series Wireless Bridge link using installationmode. When you set the link back to operational mode you loose association to the root bridge.Which action will correct the problem？（）
Which of the following accurately represents the functionality of a lightweight access point configured to operate in sniffer AP mode？（）
You have been called upon to add location-based services into an existing controller-basedwireless design which primarily encompasses handheld devices such as barcode scanners and Cisco7920 wireless IP phones.In which mode should you deploy the additional access points to achievethe density required without excessive co-channel interference？（）
How many WLANs can a Cisco Aironet 1242 in H-REAP mode support when actively connected toa wireless controller？（）
Clients using Cisco-LEAP and EAP-FAST authentication are having no problems logging on to thewireless network， but clients using PEAP are failing to log on.Which situation would result in thistype of problem？（）
A mobility group is created by a Cisco WLCM and 4402 Series Wireless LAN Controller. A client thatis anchored on the Cisco WLCM roams to an access point on the 4402 controller. You then run adebug command on the 4402 controller.Which message would best describe the establishment ofthe tunnel from the foreign controller’s perspective？（）
When configuring Cisco Secure ACS to support wireless EAP authentication， which device must be configured as a AAA client？（）