You have just finished aligning a cisco aironet 1400 series wireless bridge link using
installation mode. when you set the link back to operational mode you loose association to the root bridge.
Which action will correct the problem？（）
A.configure the bridge to force infrastructure devices to associate only to the ssid parameter.
B.enable passwords on both bridges.
C.configure the distance parameter value.
D.configure the proper channel.
您可能感興趣的試卷
你可能感興趣的試題
A.ssids are not case-sensitive.
B.ssids must be listed in the same order in the adu as they are in the access point.
C.a maximum of three ssids may be configured.
D.ssids may have a maximum of 16 characters.
A.allows client traffic， captures data on all channels
B.allows client traffic， captures data on a single channel
C.allows no client traffic， captures data on all channels
D.allows no client traffic， captures data on a single channel
You are troubleshooting a one-way call problem with a cisco 7920 wireless ip phone on a standalone wlan.
What may have caused this problem？（）
A.the minimum data rate is not set to 11 mbps.
B.publicly secure packet forwarding is enabled.
C.the access point is set to the least congested channel.
D.an address resolution protocol has been disabled.
A.operations plan
B.operations assessment
C.security administration
D.system monitoring
E.operations implementation
F.incident management
A.ciscoaironet 1400 series
B.ciscoaironet 1300 series
C.ciscoaironet 1100 series
D.ciscoaironet 1240ag series
最新試題
An REAP was supporting 16 WLANs， but now it only supports one.What happened to cause the change？（）
You are charges with implementing a secure wireless installation which will provide Internet accessto client devices but will not allow communications between wireless clients.In addition to implementing PSPF or peer-to-peer blocking on the wireless side，which of the following actionsshould you perform on the wired infrastructure？（）
Which of the following accurately represents the functionality of a lightweight access point configured to operate in sniffer AP mode？（）
The Cisco Wireless Location Appliance provides an audit trail for each device tracked for up to how many days？（）
You are troubleshooting a problem with a Cisco 7920 wireless IP phone on a standalone WLAN.The phone rings but， when you answer， the call is dropped.What may cause this problem？（）
Clients using Cisco-LEAP and EAP-FAST authentication are having no problems logging on to thewireless network， but clients using PEAP are failing to log on.Which situation would result in thistype of problem？（）
You have been called upon to add location-based services into an existing controller-basedwireless design which primarily encompasses handheld devices such as barcode scanners and Cisco7920 wireless IP phones.In which mode should you deploy the additional access points to achievethe density required without excessive co-channel interference？（）
You are troubleshooting a problem with a Cisco 7920 wireless IP phone that is causing the phoneto drop calls. The problem appears to be roaming bandwidth issue. In order to verify what kind ofissue it is， you decide to increase the bandwidth reserve for roaming on the WLAN controller tomaximum.What level do you set the bandwidth to？（）
You have a very few Cisco 7920 wireless IP phones on your network， but lots of wireless laptops.You want to increase the bandwidth available for the laptops by decreasing the bandwidth reserved for the Cisco 7920 phones.What is the lowest percentage of voice-allocated bandwidthyou can select on the WLAN controller？（）
How many WLANs can a Cisco Aironet 1242 in H-REAP mode support when actively connected toa wireless controller？（）