A.It will send the join only to the neighbor with the highest IP address.
B.It will send the join only to the neighbor with the lowest IP address.
C.It will send the join in a round-robin fashion across all neighbors.
D.It will send the join to all neighbors.
您可能感興趣的試卷
你可能感興趣的試題
A.2001：db8：3811：：1
B.2001：db8：3811：：2323
C.2001：db8：3811：：0130
D.2001：db8：3811：：3
E.2001：db8：3811：：6
A.Flooding paths and redundancy
B.Amount of routing information in the OSPF area or routing domain
C.Number of routers with Cisco Express Forwarding enabled
D.Number of neighbor adjacencies
E.Other routing protocols in use
F.OSPF timer reconstruction negotiation
G.Redistribution with BGP neighbors
H.Redistribution with other IGP routing protocols， such as RIP or EIGRP
A. BGP peers must be Layer 2-adjacent
B. EBGP multihop is not configured
C. The firewall is not configured to allow IP protocol 89
D. The firewall is not configured to allow UDP 179.
Refer to the exhibit. Users on the 199.155.24.0 network are unable to reach the 172.16.10.0 network. What is the most likely solution？（）
A. Router ISP1 should be configured to peer with router B
B. Router ISP2 should be configured with no synchronization
C. Router ISP1 should be configured with no synchronization
D. Router ISP2 should be configured with no auto-summary.
E. Router ISP1 or IPS2 should be configured with network 176.16.10.0 mask 255.255.255.0
A.It relies on IPv6 to do the fragmenting.
B.It splits the LS Update packet into smaller packets.
C.It splits the LSA into smaller router LSA packets.
D.It produces an error.
最新試題
How does an IPv6 router deal with a packet that is larger than the outgoing interface MTU？（）
Which command is used to enable SSM with the range 232.0.0.0 - 255.0.0.0？（）
Based on the exhibit presented. What will be the objective of this route map when applied to traffic passing through a router？（）
Which two are differences between IGMPv2 and IGMPv3 reports？（）
Which three protocols or applications should be placed in a class that is configured with WRED？（）
What is also called Type 0 authentication in OSPF on Cisco Routers？（）
You are the network administrator of an enterprise with a main site and multiple remote sites. Your networkcarries both VOIP and data traffic. You agree with your service provider to classify VOIP and data trafficaccording to the different service RFCs. How can your data and VOIP traffic be marked？（）
Which two of these are used in the selection of a root bridge in a network utilizing Spanning Tree ProtocolIEEE 802.1 D？（）
Which protocol and port have been assigned by IANA for RADIUS authentication？（）
Which three message types are valid PIMv2 message types？（）