A.Designated Root Cost
B.bridge ID priority
C.max age
D.bridge ID MAC address
E.Designated Root Priority
F.forward delay
您可能感興趣的試卷
你可能感興趣的試題
A.one global STP instance for all VLANs
B.one STP instance for each VLAN
C.one STP instance per set of VLANs
D.one STP instance per set of bridges
A.Attempt to TELNET from the router connected to the inside of the firewall to the router connected to theoutside of the firewall. If telnet works, BGP will work, since telnet and BGP both use TCP to transportdata.
B.Ping from the router connected to the inside interface of the firewall to the router connected to theoutside interface of the firewall. If you can ping between them, BGP should work, since BGP uses IP totransport packets.
C.There is no way to make BGP work across a firewall without special configuration, so there is no simpletest that will show you if BGP will work or not, other than trying to start the peering session.
D.There is no way to make BGP work across a firewall.
A.ip pim rp-address
B.ip pim ssm
C.ip pim sparse-mode
D.ip pim passive
A.MD5
B.There is no Type 0 authentication
C.SHA1
D.Null
A.UDP/1812
B.UDP/1813
C.TCP/1812
D.TCP/1813
最新試題
What is also called Type 0 authentication in OSPF on Cisco Routers?()
Which command is used to enable SSM with the range 232.0.0.0 - 255.0.0.0?()
In PIM-SM what control plane signaling must a multicast source perform before it begins to send multicasttraffic to a group?()
Which types of prefixes will a router running BGP most likely advertise to an IBGP peer, assuming it is notconfigured as a route reflector?()
How does an IPv6 router deal with a packet that is larger than the outgoing interface MTU?()
What is the command to configure RSVP to reserve up to one-tenth of a Gigabit link,but only allow eachindividual flow to use 1 MB/s?()
Which protocol and port have been assigned by IANA for RADIUS authentication?()
In order to configure two routers as anycast RPs, which of these requirements, af a minimum, must besatisfied?()
Which message type is constructed and sent from an MSDP router to its MSDP peers when it receives a PIM register message knowing that the MSDP router is also configured as an RP for the PIM domain?()
Choose two commands that are required to enable multicast on a router, when it is known that thereceivers use a specific functionality of IGMPv3.()