A.hydraulic
B.electric
C.steam
D.diesel
您可能感興趣的試卷
你可能感興趣的試題
A.increase the amount of cooling water to the condenser
B.decrease the amount of cooling water to the condenser
C.add more refrigerant to the system
D.remove some refrigerant from the system
A.Heat is given off from a high temperature region known as a heat sink
B.Heat transfer rate is affected most by the size of the heat sink involved
C.Heat transfer rate is affected most by the temperature difference between the heat source and the heat sink
D.Heat transfer by radiation will occur only by mass motion of a fluid substance
A.Maritime Safety Administration
B.Master of the vessel
C.Chief Engineer
D.Chief Mate
A.size of the heat sink
B.temperature difference between the regions
C.size of the heat source
D.total heat of the system
A.the four-way control valve failing to shift
B.the bleeder valve sticking in the open position
C.cold hydraulic fluid
D.a clogged air vent falter on the oil reservoir
最新試題
The general purpose of a heat exchanger is to ().
A gradual decrease in the discharge pressure of an operating hydraulic pump can be caused by ().
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by ().
Which of the following statements is correct concerning heat transfer?()
An excessive charge of refrigerant in an air-cooled refrigeration system can cause ().
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should ().
The usual symptoms of cavitation in a centrifugal pump is ().
Thermostatic expansion valves can be adjusted for ().
Low compressor head pressure in a refrigeration system can be caused by().
The output volume of a positive fixed displacement pump can be changed only by ().