A.Heat is given off from a high temperature region known as a heat sink
B.Heat transfer rate is affected most by the size of the heat sink involved
C.Heat transfer rate is affected most by the temperature difference between the heat source and the heat sink
D.Heat transfer by radiation will occur only by mass motion of a fluid substance
您可能感興趣的試卷
你可能感興趣的試題
A.Maritime Safety Administration
B.Master of the vessel
C.Chief Engineer
D.Chief Mate
A.size of the heat sink
B.temperature difference between the regions
C.size of the heat source
D.total heat of the system
A.the four-way control valve failing to shift
B.the bleeder valve sticking in the open position
C.cold hydraulic fluid
D.a clogged air vent falter on the oil reservoir
A.add fluid that is the same color as the fluid in the reservoir
B.add turbine oil because it is always a good substitute
C.add any oil that has the same viscosity as the hydraulic fluid
D.check the winch manufacturers instruction book
A.changing the angle of the tilting plate
B.changing the speed of the pump
C.moving the slide block and rotor
D.moving the shaft trunnion block
最新試題
A salinity indicator is used to determine the ().
On tank vessels equipped with power operated cargo tank valves, the type of power operator most commonly used is ().
When a refrigeration compressor has developed a high head pressure as a result of a refrigerant overcharge, you should ().
Thermostatic expansion valves can be adjusted for ().
If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be ().
If the suction pressure at the refrigeration compressor is below normal, the cause can be().
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should ().
Which of the following problems could cause the high pressure cutout switch to shut down the compressor in a refrigeration system?()
Heavy wear in a particular area of the inner circumference of a packing ring may be caused by ().
Which of the problems listed would came the discharge temperature of an R-12 refrigeration compressor to increase?()