A. ISATAP
B. NATV6
C. manually configured overlay tunnels
D. dual stack configurations
您可能感興趣的試卷
你可能感興趣的試題
Which configuration will enable OSPF for IPv6 on FastEthernet 0/0/0?（）
A.A
B.B
C.C
D.D
A. enable backbone fast
B. enable uplink fast
C. disable portfast
D. enable portfast
A. Shared
B. Point-to-Point
C. Designated
D. Multiaccess non-broadcast
As an experienced network engineer, you are asked to troubleshoot a CIS network outage. During the troubleshooting process, you notice that one of your colleagues connects additional devices to the network with the use of his own switch. With the purpose of improving speed, the switch is attached to both network ports in an office, which leads to bridge loop.
Enabling which of the following feature will be able to prevent this problem from happening again?（）
A.GLBP
B.RSTP
C.BPDU guard
D.root guard
A. Disables the interfaces to prevent traffic flow
B. Clears all the configurations on the interface
C. Switches the port from access mode to trunk mode
D. Converts the port from physical Layer 2 port to physical Layer 3 port
最新試題
Which keyword is used with the debug ipv6 [keyword] command to troubleshoot neighbor discovery problems?（）
Which configuration will enable OSPF for IPv6 on FastEthernet 0/0/0?（）
When a Cisco router is configured for SSH, it acts as an （）?
Refer to the exhibit. Analyze the two traceroutes that are displayed. Which of these statements is correct in describing what most likely caused the traceroute differences?（）
Which command displays only those entries in a BGP table with specific AS_PATH attributes?（）
Refer to the exhibit. You have a non-Cisco switch that is not communicating properly while connected to the distribution-layer Cisco switching fabric.Which two best-practice actions can you take to overcome this problem? （）(Choose two.)
On the Catalyst 6500 Series switch, which command is used to establish a console connection to the Firewall Services Module?（）
What is the purpose of using VPN hardware acceleration equipment?（）
What are four advantages to using tunnel brokers in an IPv6 transition environment?（）
Refer to the exhibit. You want to minimize the downtime that results from supervisor engine switchovers on Cisco 6500 Series Switches and Cisco 7600 Series Routers. To achieve this, you are considering deploying a Cisco Nonstop Forwarding with Stateful Switchover solution using OSPF.In the exhibit you can see the output of the show ip ospf neighbor detail command.Which trait of systems using Cisco Nonstop Forwarding with Stateful Switchover and OSPF is shown in the exhibit output and will impact your plan?（）