A. Protocol and IP source only
B. IP Source, IP Destination and ports
C. IP Source Only
D. IP Destination Only
您可能感興趣的試卷
你可能感興趣的試題
A Cisco Catalyst switch is part of the CIS network. As an experienced network administrator, you are thinking of filtering the traffic within VLANI00 with the use of a VACL named "test" on that switch.
Which of the following command will enable that?（）
A. interface vlan 100 ip access-group test in
B. interface vlan 100 ip access-group test
C. vlan access-map test 100
D. vlan filter test vlan-list 100
A. Information about port roles is sent to all switches.
B. RSTPs that are based on Cisco products require no additional configuration.
C. Features such as UplinkFast and BackboneFast are compatible with RSTP.
D. An RSTP that is based on Cisco products generally performs better than the Cisco proprietary 802.1D enhancements.
A.ISSU，OSPF，IS-IS
B.IETF，OSPF，ISSU
C.IS-IS，EIGRP，SSO，BGP
D.EIGRP，BGP，OSPF，IS-IS
A. Automatic switchover from active to standby on primary supervisor failure
B. Reset of the primary supervisor.
C. Manual switchover from active to standby supervisor
D. Manual switchover from standby to active supervisor
A. show redundancy states, redundancy, mode sso
B. show redundancy states, mode sso, redundancy
C. redundancy, mode sso, show redundancy states
D. mode sso, redundancy, show redundancy states
最新試題
As a network administrator, you issue the interface auto qos voip cisco-phone command on a port in an edge network. It is possible for a Cisco Catalyst switch to check if a Cisco IP Phone is directly attached to that port by:（）
Which Cisco IOS command is used to troubleshoot a problem in which a BGP session stays in the active state?（）
What is the purpose of using VPN hardware acceleration equipment?（）
You are trying to initiate an SSH connection to a remote router and are getting rejected with an error code of 0. Which of these might be the cause of the error?（）
Referring to the partial Cisco Catalyst switch configuration shown, which two of these statements are correct? （）(Choose two.)
Which command is used to view IPv6 parameters related to the BGP process?（）
On the Catalyst 6500 Series switch, which command is used to establish a console connection to the Firewall Services Module?（）
What is the most likely reason that an IBGP route that has been selected as a best route is not entered into the IP routing table?（）
Which of the following allows network administrators to easily apply common services and employ features across Cisco switches, routers, and access points with an intuitive GUI?（）
In a high-availability network, which command, when placed on ports that have connected end stations, will allow you to prevent delays in service for end stations by placing a port in blocking mode?（）