A.Fresnel units
B.decibels
C.EIRP
D.milliamperes
E.ohms
您可能感興趣的試卷
你可能感興趣的試題
A.rogue access point detection in the coverage area
B.multipath issues in the coverage area
C.number of VoWLAN users in the coverage cell
D.call capacity requirements of the coverage area
A.green
B.blue
C.yellow
D.red
E.purple
F.white
A.SNR
B.noise floor
C.level of interference
D.Received Signal Strength Indicator
A.Report the problem to the FCC
B.Report the problem to the FAA
C.Remove channel 36 from the DCA channel list
D.Configure channel 36 to bond to channel 40 for a 40Mhz 802.11n channel
A.40mW maximum transmit power
B.average power level of the VoWLAN clients
C.100mW transmit power
D.lowest power level of the VoWLAN clients
最新試題
How is attenuation measured？（）
Cisco recommends a decibel referenced to 1 milliwatt signal level for the coverage cell edge at thepredetermined data rate that is needed to support the VoWLAN device and call capacityrequirements. What is that signal level value for Cisco Unified Wireless IP Phones 7920， 7921G， and7925G？（）
In which three frequency bands does the Cisco Spectrum Expert Wi-Fi tool perform spectrumanalysis？ （）
Which three formats can be used to import floor maps in Cisco WCS v5.2？（）
Which can NOT be selected for supported services in Cisco WCS Planning Tool？（）
A design requires 100 access points with high channel bandwidth and disabled lower data rates.How are the data rates set on the Cisco WLC and Cisco WCS？（）
For an active Cisco Unified Wireless IP Phone 7921G 5 GHz site survey， what are the mostappropriate client test settings to use with the AirMagnet site survey tool？（）
Which two Cisco antennas provide better isolation from RF sources that might be located behindthe antennas？（）
In an outdoor bridge link， what is calculated by using this formula： transmitter power + antennagain - insertion OR cable loss（）？
What will cause wireless voice devices to perform poorly？（）