During the installation of the cisco wcs version 4.0，an error occurs.
Where would you look for the installation log，in order to learn more about this error？（）
A.at the root of the installation drive
B.in the cisco wcs installation directory
C.on the desktop of the server
D.in the cisco wcs\logs directory
您可能感興趣的試卷
你可能感興趣的試題
You are configuring an rf group of controllers that coordinate radio resource management calculations.
What is the maximum number of wlan controllers that you can add？（）
A.17
B.20
C.12
D.24
When configuring a wlan controller for a voice application using cisco 7920 wireless ip phones.
which two general control settings should you select？（）
A.multicast on
B.aggressive load balancing off
C.multicast off
D.ap fallback on
E.aggressive load balancing on
F.ap fallback off
You are installing a cisco 4402 series wireless lan controller.
Which type of interface should you use on the controller’s distribution port？（）
A.1000base-sx sfp
B.10/100/1000 mbps rj45
C.10/100 mbps rj45
D.10000base-sx
By default，on the wlan controller for a voice application using cisco 7921 wireless ip phones.
what is the percentage of rf bandwidth that can be dedicated to the phones？（）
A.75 percent
B.85 percent
C.56 percent
D.55 percent
A.clients connected to the rogue access point must be able to connect to the containment controller-based access point.
B.multiple controller-based access points will load-balance the containment task using fewer resources than a single access point.
C.clients connected to the rogue access point may be out of the range of the controller-based access point providing containment.
D.each controller-based access point can handle only a limited amount of clients connected to the rogue access points.
最新試題
Which of the following accurately represents the functionality of a lightweight access point configured to operate in sniffer AP mode？（）
You want to dynamically assign users to an 802.1Q VLAN as a result of their authentication. Inorder to accomplish this.Which two IETF RADIUS attributes should you configure on the CiscoSecure ACS？ （）
You are troubleshooting a problem with a Cisco 7920 wireless IP phone on a standalone WLAN.The phone rings but， when you answer， the call is dropped.What may cause this problem？（）
A client roams from H-REAP AP1 to H-REAP AP2. The client is unable to associate to H-REAP AP2.H-REAP AP2 has six other clients associated to it， which continue to pass traffic.What has causedthis problem？（）
You are charges with implementing a secure wireless installation which will provide Internet accessto client devices but will not allow communications between wireless clients.In addition to implementing PSPF or peer-to-peer blocking on the wireless side，which of the following actionsshould you perform on the wired infrastructure？（）
On a Cisco Aironet 802.11 a/b/g wireless LAN client adapter，the status LED and activity LED are alternating on and off.What does this indicate？（）
You review the Failed Attempts logs on an AAA server and find： "unknown network access servererror." Which failure could produce this error？（）
You are troubleshooting a problem with a Cisco 7920 wireless IP phone that is causing the phoneto drop calls. The problem appears to be roaming bandwidth issue. In order to verify what kind ofissue it is， you decide to increase the bandwidth reserve for roaming on the WLAN controller tomaximum.What level do you set the bandwidth to？（）
Which of the following parameter sets must be configured on the Cisco Wireless Location Appliance？（）
When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones，which two general control settings should you select？（）