單項選擇題What is the final step of the core baselining process? ()

A. Implement threshold monitoring using RMON.
B. Implement monitoring using SNMP or RMON.
C. Poll and record specific SNMP MIB objects from the device.
D. Verify that SNMP MIB is supported in the relevant core device.


您可能感興趣的試卷

你可能感興趣的試題

1.多項選擇題When HSRP is configured on a network, which two of these items are provided, which are sharedbetween the routers that run HSRP? ()(Choose two.)

A. TCP-based hello packets
B. the impact of flapping links if timers are too low
C. a shared single interface
D. the ability to track serial interfaces
E. UDP-based hello packets

2.多項選擇題What are two characteristics of the relationship between the Cisco PIN architecture and CiscoValidated Designs? ()(Choose two.)

A. Cisco is focusing on Cisco Validated Designs as a means to driving integrated networks.
B. Cisco is focusing on the PIN architecture as a means to driving integrated networks.
C. The Cisco PIN architecture is a critical mechanism for supporting integrated markets because it can be implemented quickly.
D. The Cisco Validated Designs program provides critical mechanisms for supporting integrated markets because the mechanisms can be implemented quickly.
E. Cisco Validated Designs can be implemented quickly without customer input.

3.多項選擇題Which three of the following steps are mandatory when configuring MPLS on Cisco IOS?()(Choose three.)

A. start LDP
B. enable CEF switching
C. configure the MPLS ID
D. disable IP TTL propagation
E. configure conditional label advertising
F. enable label switching on frame mode interfaces

4.單項選擇題Which command retrieves and displays information about each Cisco product in the form of aUDI?()

A. show status
B. show hardware
C. show inventory
D. show environment

5.單項選擇題Why is there no need to configure complex overlay network topologies when using Cisco WAAS? ()

A. remote scheduling of software distribution
B. comprehensive logs, reports, and graphs
C. automatic discovery of Cisco WAEs
D. content pre-positioning

最新試題

You are an experienced network administrator in an international corporation. One of your clients asks you to configure a network for a financial trading center which requires multiple high-value transactions.And the transactions are very important to the client. In such a situation, which two of the following are basic and most important requirements concerning the configuration? ()(Choose two.)

題型:多項選擇題

As a network administrator, you issue the interface auto qos voip cisco-phone command on a port in an edge network. It is possible for a Cisco Catalyst switch to check if a Cisco IP Phone is directly attached to that port by:()

題型:單項選擇題

Refer to the exhibit. Which SSH sessions will the SSH server accept?()

題型:單項選擇題

As an experienced network engineer, you are asked to troubleshoot a CIS network outage. During the troubleshooting process, you notice that one of your colleagues connects additional devices to the network with the use of his own switch. With the purpose of improving speed, the switch is attached to both network ports in an office, which leads to bridge loop.Enabling which of the following feature will be able to prevent this problem from happening again?()

題型:單項選擇題

What is the purpose of using VPN hardware acceleration equipment?()

題型:單項選擇題

Refer to the exhibit. You have a non-Cisco switch that is not communicating properly while connected to the distribution-layer Cisco switching fabric.Which two best-practice actions can you take to overcome this problem? ()(Choose two.)

題型:多項選擇題

Which three of these items are IPv6 transition mechanisms? ()(Choose three.)

題型:多項選擇題

What is the most likely reason that an IBGP route that has been selected as a best route is not entered into the IP routing table?()

題型:單項選擇題

What are four advantages to using tunnel brokers in an IPv6 transition environment?()

題型:多項選擇題

Which Cisco IOS command is used to troubleshoot a problem in which a BGP session stays in the active state?()

題型:單項選擇題