A.VDSL
B.HDSL
C.ADSL
D.SDSL
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit.
Which three statements describe the steps that are required to configure an IPsec site-to-site VPN using a GRE tunnel？（）
A.The command access-list 110 permit gre must be configured to specify which traffic will be encrypted.
B.The command access-list 110 permit ip must be configured to specify which hosts can use the tunnel.
C.The tunnel destination 172.17.63.18 command must be configured on the Tunnel0 interface.
D.The tunnel mode gre command must be configured on the Tunnel0 interface.
E.The tunnel source Ethernet1 command must be configured on the Tunnel0 interface.
F.The tunnel source Tunnel0 command must be configured on the Tunnel0 interface.
A.AlarmSeverity
B.AlarmKeepalive
C.AlarmTraits
D.EventMedia
E.EventAlarm
F.EventAction
A.Cable modems only operate at Layer 1 of the OSI model.
B.Cable modems operate at Layers 1 and 2 of the OSI model.
C.Cable modems operate at Layers 1， 2， and 3 of the OSI model.
D.A function of the cable modem termination system （CMTS） is to convert the modulated signal from the cable modem into a digital signal.
E.A function of the cable modem termination system is to convert the digital data stream from the end user host into a modulated RF signal for transmission onto the cable system.
A.Dead Peer Detection （DPD）
B.CDP
C.isakmp keepalives
D.GRE keepalive mechanism
E.The hello mechanism of the routing protocol across the IPsec tunnel
Refer to the exhibit. Which statement is true about the partial MPLS configuration that is shown？（）
A.The route-target both 100：2 command sets import and export route-targets for vrf2.
B.The route-target both 100：2 command changes a VPNv4 route to a IPv4 route.
C.The route-target import 100：1 command sets import route-targets routes specified by the route map.
D.The route-target import 100：1 command sets import route-targets for vrf2 that override the other route-target configuration.
最新試題
What are the four fields in an MPLS label？（）
Refer to the exhibit. The show mpls interfaces detail command has been used to display information about the interfaces on router R1 that have been configured for label switching. Which statement is true about the MPLS edge router R1?（）
What are three features of the Cisco IOS Firewall feature set？（）
What are three configurable parameters when editing signatures in Security Device Manager （SDM）？（）
Which three statements about the Cisco Easy VPN feature are true？（）
Which three statements are true when configuring Cisco IOS Firewall features using the SDM？ （）
Refer to the exhibit. Which statement is true about the partial MPLS configuration that is shown？（）
Which three MPLS statements are true？（）
Refer to the exhibit. Which order correctly identifies the steps to provision a cable modem to connect to a headend as defined by the DOCSIS standard？（）
If an edge Label Switch Router （LSR） is properly configured，which three combinations are possible？（）