You are configuring a Cisco multilayer switch for the Company network.
Which command would you use to configure a port to act as a routed interface？（）
A. ip routing
B. switchport mode trunk
C. no switchport
D. switchport trunk native vlan 1
E. None of the other alternatives apply
您可能感興趣的試卷
你可能感興趣的試題
Which of the following could be used to provide a Layer 3 data path between separate VLANs？（）
A. VLAN trunking
B. An external router
C. An internal route processor
D. VLAN capable bridge
E. EtherChannel
Inter-VLAN routing has been implemented in the Company network. In VLAN routing，
what are some of the disadvantages of designing a router-on-stick configuration？ （）
A. InterVLAN routing cannot be filtered by the router.
B. The router becomes a single point of failure for the network.
C. Routers will not route STP BPDUs.
D. There is a possibility of inadequate bandwidth for each VLAN.
E. Additional overhead on the router can occur.
F. NetFlow Switching is required for InterVLAN accounting.
The Company network needs to pass traffic between VLANs.
Which device should be used to accomplish this？ （）
A. Hub
B. Switch
C. Router
D. Bridge
E. None of the other alternatives apply
pany has implemented numerous multilayer switches that utilize FIB tables.
Which statement is true about the Forward Information Base （FIB） table？（）
A. The FIB is derived from the IP routing table and is optimized for maximum lookup throughput.
B. The FIB table is derived from the Address Resolution Protocol table， and it contains Layer 2 rewrite （MAC） information for the next hop.
C. When the FIB table is full， a wildcard entry redirects traffic to the Layer 3 engine.
D. The FIB lookup is based on the Layer 2 destination MAC address.
E. None of the other alternatives apply
Refer to the exhibit.
What type of attack is being defended against？ （）
A. snooping attack
B. rogue device attack
C. STP attack
D. VLAN attack
E. spoofing attack
F. MAC flooding attack
最新試題
Which two statements are true when the extended system ID feature is enabled？ （）
Which three statements about STP timers are true？（）
Refer to the exhibit. What will happen when one more user is connected to interface FastEthernet 5/1？ （）
Refer to the exhibit. Switch S2 contains the default configuration. Switches S1 and S3 both have had the command spanning-tree mode rapid-pvst issued on them. What will be the result？（）
What will occur when a nonedge switch port that is configured for Rapid Spanning Tree does not receive a BPDU from its neighbor for three consecutive hello time intervals？（）
Which statement is correct about the use of the virtual interface on a WLC ？（）
Refer to the exhibit. What command was issued on the Layer 3 switch Sw1 between Exhibit #1 and Exhibit #2？（）
Which three statements are true of the Link Aggregation Control Protocol （LACP）？（）
What is the configured priority value of the Vlan105’s group on DS2 ？（）
Refer to the exhibit. What does the command channel-group 1 mode desirable do？ （）