單項選擇題You are securing a network for TestKing and want to apply an ACL (access control list) to an interface of a router. Which one of the following commands would you use?（）

A. permit access-list 101 out
B. ip access-group 101 out
C. apply access-list 101 out
D. access-class 101 out
E. ip access-list e0 out


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題What is the purpose of assigning an IP address to a switch?（）

A. Provides local hosts with a default gateway address
B. Allows remote management of the switch.
C. Allows the switch to respond to ARP requests between two hosts
D. Ensures that hosts on the same LAN can communicate with each other.

2.單項選擇題As a TestKing trainee you are required to set the default gateway on a Cisco switch to the IP address of 192.168.1.115. Which IOS command should you use?（）

A. TestKSwitch(config)# ip route-default 192.168.1.115
B. TestKSwitch(config)# ip default-gateway 192.168.1.115
C. TestKSwitch(config)# ip route 192.168.1.115 0.0.0.0
D. TestKSwitch(config)# ip default-network 192.168.1.115

3.多項選擇題Which interface commands would you enter on a Catalyst 2900 switch, if your goal was to bring all VLAN traffic to another directly connected switch?（）

A. Switch(config-if)# vlan all
B. Switch(config-if)# switchport trunk encapsulation dot1q
C. Switch(config-if)# switchport access vlan all
D. Switch(config-if)# switchport mode trunk
E. Switch(config-if)# switchport access vlan 303

5.單項選擇題After making some network changes you power off and then power on your Cisco router. What sequence of events occurs when a router is powered up?（）

A. Perform POST, locate configuration statements, apply configuration statements, locate Cisco IOS software, and load Cisco IOS software.
B. Locate Cisco IOS software, load Cisco IOS software, locate configuration statements, apply configuration statements, and perform POST.
C. Test software routines, POST, load configuration files, load Cisco IOS software, test Cisco IOS software.
D.POST, locate Cisco IOS software, load the Cisco IOS software, locate configuration statements, and apply configuration statements.
E. Load and test IOS, load configuration files, test software routines, POST.

最新試題

Which connections allow the use of full-duplex Ethernet?（）

題型：多項選擇題

What should the configuration register value be after successfully completing the password recover procedure and returning the router to normal operation? （）

題型：?jiǎn)雾?xiàng)選擇題

Which statement describes the rule of split horizon?（）

題型：?jiǎn)雾?xiàng)選擇題

Given a subnet mask of 255.255.255.224, which of the following addresses can be assigned to network hosts?（）

題型：多項選擇題

A network host is configured as follows: Host IP address: 192.168.16.183 Subnet mask: 255.255.255.224 Default gateway: 192.168.16.190 Which of the following statements describe the network to which this host is attached?（）

題型：多項選擇題

A technician at TestKing needs to update the network documentation. One of the tasks includes documenting the name of the IOS image file of each router in the network.Which commands could be used to find this information?（）

題型：?jiǎn)雾?xiàng)選擇題

Which of the following contribute to congestion on an Ethernet network?（）

題型：多項選擇題

All WAN links is side the TestKing.com network use PPP with for authentication security. Which command will display the CHAP authentication process as it occurs between two routers in the network?（）

題型：?jiǎn)雾?xiàng)選擇題

Which characteristics are representative of a link-state routing protocol?（）

題型：多項選擇題

A Router with a BRI/T interface will be used for an ISDN Connection what other ISDN device is required to complete this connection? （）

題型：?jiǎn)雾?xiàng)選擇題