Based on the graphic below， which Catalyst switch interface command should be issued in orderfor the switch to instruct the phone to override the incoming CoS from the CK-PC before sendingthe packet to the switch？（）
A.switchport priority extend cos 11
B.switchport priority extend cos 2
C.mis qos cos 2
D.mis qos cos 2 override
您可能感興趣的試卷
你可能感興趣的試題
A.switchport voice vlan vlan-id
B.mls qos trust device cisco-phone
C.switchport priority extend cos_value
D.mls qos trust cos
E.mls qos trust override cos
Look at the graphic below， the connectivity between Cisco IP phone access port and theworkstation CK-PC has been established， how to manage the traffic？（）
A.The IP phone access port will override the priority of the frames received from the CK-PC
B.The IP phone access port would trust the priority of the frames received from the CK-PC
C.The switch port FaO/4 would neglect the priority of the frames received from the CK-PC
D.The switch port FaO/4 would trust the priority for the frames received from the CK-PC
An IP phone connects a user to a switch as shown below：
Based on the diagram shown above， which statement is true about the voice traffic coming to theswitch access port that is connected to the IP phone？（）
A.A PC connected to a switch port via an IP phone is unaware of the presence of the phone
B.The traffic on the voice VLAN must be tagged with 802.1p encapsulation in order to coexist onthe same LAN segment with a PC
C.To improve the quality of the voice traffic， no other devices should be attached to the IP phone
D.The voice VLAN must be configured as a native VLAN on the switch
E.A PC connected to a switch port via an IP phone must support a trunking encapsulation
A.Antenna power is a relative value reference to dBi
B.LWAPP allows encrypted communications between lightweight access points and WLANcontrollers.
C.Characteristics of antennas are directionality， gain， and polarization
D.Power over Ethernet （PoE） is only available when a WLAN controller is integrated into thenetwork
E.The WLAN solution Engine （WLSE） is used to control lightweight access points
F.One of the advantages of the lightweight WLAN solution is that the devices act indepently
Network topology exhibit：
In this WLAN segment， what are three requirements for configuring these Aironet access points（APs） that will allow for all wireless clients to work without service interruption while roaming fromaccess point to access point？（）
All access points should be configured....
A....with a unique IP subnet range
B....with identical SSIDs
C....within the same IP subnet
D....with the same guest mode SSID
E....only with the native VLAN
F....with the native VLAN
最新試題
Drag each element of the Cisco IOS Firewall Feature Set from the above and drop onto itsdescription on the below.
Which two encapsulation methods require that an 827 ADSL router be configured with a PPPusername and CHAP password？（）
Drag the correct statements about MPLS-based VPN on the left to the boxes on the right.（Not allstatements will be used）
Drag the IPsec protocol description from the above to the correct protocol type on the below.（Notall descriptions will be used）Drag and Drop question， drag each item to its proper location.
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec， which two parameters are required when defining the tunnel interfaceinformation？（）
Drag and drop the steps in the process for provisioning a cable modem to connect to a headendon the above to the below in the order defined by the DOCSIS standard.
Drag the DSL local loop topic on the left to the correct descriptions on the right.
Drag and drop the xDSL type on the above to the appropriate xDSL description on the below.
Authentication is the process of determining if a user or identity is who they claim to be. Refer tothe exhibit. Which statement about the authentication process is correct？（）
Which statement about PPPoA configuration is correct？（）