This item contains several questions that you must answer. You can view these questions byclicking on the Questions button to the left. Changing questions can be accomplished by clickingthe numbers to the left of each question. In order to complete the questions， you will need to referto the SDM and the topology， neither of which is currently visible. To gain access to either thetopology or the SDM， click on the button to left side of the screen that corresponds to the sectionyou wish to access. When you have finished viewing the topology the SDM， you can return to yourquestions by clicking on the Questions button to the left.
Off Shore Industries is a large worldwide sailing charter. The company has recently upgraded itsInternet connectivity. As a recent addition to the network engineering team， you have been taskedwith documenting the active Firewall configurations on the Annapolis router using the Cisco Routerand Security Device Manager （SDM） utility. Using the SDM output from Firewall and ACL Tasksunder the Configure tab， answer the following questions：
Which two options would be correct for a permissible incoming TCP packet on an untrustedinterface in this configuration？（）
A.The packet has a source address of 172.16.29.12
B.The packet has a source address of 10.94.61.29
C.The session originated from a trusted interface
D.The application is not specified within the inspection rule SDM_LOW
E.The packet has a source address of 198.133.219.144
您可能感興趣的試卷
你可能感興趣的試題
A.Following the traffic path
B.Top-down
C.Comparing configurations
D.Bottom-up
E.Divide and conquer
F.ExamineS LAs
Which two of the following descriptions are correct according to the displayed output of thecommand show ip bgp summary？（）
A.The BGP session to the 10.1.1.1 neighbor is established
B.The router is trying to create a BGP peering session with the 10.1.1.1 neighbor
C.The BGP session to the 10.3.3.3 neighbor is created， but the router received no BGP routingupdates from the 10.3.3.3 neighbor
D.The router is attempting to establish a BGP peering session with the 10.2.2.2 neighbor
A.Extranet VPN
B.Managed overlay VPN topology
C.Hub-and-spoke VPN topology
D.Central-site VPN topology
E.Full mesh VPN topology
F.Remote-access VPN topology
A.The interface must be configured as a Multilink PPP interface.
B.The correct bandwidth should be configured on the interface.
C.A QoS policy must not be currently attached to the interface.
D.CEF must be enable
E.AutoQoS must be enabled globally before it can be enabled on the interface.
F.An IP address must be configured on the interface if its speed is equal to or less than 768 kbps.
A.show ip bgp
B.show ip bgp paths
C.show ip bgp peers
D.show ip bgp summary
E.show ip bgp protocols
最新試題
Identify the recommended steps for worm attack mitigation by dragging and dropping them into thetarget area in the correct order.
A new router was configured with the following commands：The configuration above was found on an Internet Service Provider’s （ISP） Multiprotocol LabelSwitching （MPLS） network. What is its purpose？（）
Drag and drop question. The upper gives the MPLS functions， the bottom describes the planes.Drag the above items to the proper location at the below
This item contains several questions that you must answer. You can view these questions byclicking on the Questions button to the left. Changing questions can be accomplished by clicking the numbers to the left of each question. In order to complete the questions， you will need to referto the SDM and the topology， neither of which is currently visible.To gain access to either the topology or the SDK click on the button to left side of the screen thatcorresponds to the section you wish to access. When you have finished viewing the topology theSDK you can return to your questions by clicking on the Questions button to the left.Which defined peer IP address an local subnet belong to Crete？（）
Match the xDSL type on the above to the most appropriate implementation on the below.
Study this exhibit carefully. What information can be derived from the SDM firewall configurationdisplayed？（）
Drag and drop each function on the above to the hybrid fiber-coaxial architecture component that itdescribes on the below.
This item contains several questions that you must answer. You can view these questions byclicking on the Questions button to the left. Changing questions can be accomplished by clickingthe numbers to the left of each question. In order to complete the questions， you will need to referto the SDM and the topology， neither of which is currently visible. To gain access to either thetopology or the SDK click on the button to left side of the screen that corresponds to the sectionyou wish to access. When you have finished viewing the topology the SDK you can return to yourquestions by clicking on the Questions button to the left.Which IPSec rule is used for the Olympia branch and what does it define？（）
Drag and drop the xDSL type on the above to the appropriate xDSL description on the below.
IPSec VPN is a widely-acknowledged solution for enterprise network. Which three IPsec VPNstatements are true？（）