A. you can apply multiple access lists with the same protocol or in different direction.
B. you can config one access list,per direction,per layer 3 protocol
C. you can place as many access lists as you want on any interface
D. you can apply only one access list on any interface
您可能感興趣的試卷
你可能感興趣的試題
A. spanning-tree mode rapid-pvst
B. spanning-tree uplinkfast
C. spanning-tree backbonefast
D. spanning-tree mode mst
A. they run a spell check on host names to ensure accurate routing
B. they map individual hosts to their specific IP address
C. they convert domain names into IP address
D. Given an IP address,they determine the name of the host that is…
A. Flash,TFTP server,ROM
B. Flash,NVRAM,ROM
C. ROM,NVRAM,TFTP server
D. NVRAM,TFTP server,ROM
E. TFTP server,Flash,NVRAM
A. show session
B. show cdp neighbors
C. show users
D. show queue
A. transport type all
B. transport output all
C. transport preferred all
D. transport input all
最新試題
Which device might be installed at a branch office to enable and manage an IPsec site-to-site VPN?（）
Which IPsec security protocol should be used when confidentiality is required?（）
When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?（）
Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?（）
After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?（）
The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）
If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?（）
Three switches are connected to one anther via trunk ports.Assuming the default switch configuration,which switch is elected as the root bridge for the spanning-tree instance of vlan 1?（）
While troubleshooting a network problem,a technician discovers that the current copy of the Cisco IOS is outdated and needs to be updated.Which of the following commands would the technician issue to replace the Cisco router IOS with the newer version?（）
Which pairing reflects a correct protocol-and-metric relationship?（）