多項選擇題Which two addresses can be assigned to a host with a subnet mask of 255.255.254.0?()

A.113.10.4.0
B.186.54.3.0
C.175.33.3.255
D.26.35.2.255
E.17.35.36.0


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題The network default gateway applying to a host by DHCP is 192.168.5.33/28.Which option is the valid IP address of this host?()

A.192.168.5.55
B.192.168.5.47
C.192.168.5.40
D.192.168.5.32
E.192.168.5.14

2.單項選擇題Cisco Catalyst switches CAT1 and CAT2 have a connection between them using ports FA0/13.An 802.1Q trunk is configured between the two switches.On CAT1,VLAN10 is chosen as native,but on CAT2 the native VLAN is not specified.What will happen in this scenario?()

A.802.1Q giants frames could saturate the link.
B.VLAN10 on CAT1 and VLAN1 on CAT2 will send untagged frames.
C.A native VLAN mismatch error message will appear.
D.VLAN10 on CAT1 and VLAN1 on CAT2 will send tagged frames.

3.單項選擇題Which command shows system hardware and software version information?()

A.show configuration
B.show environment
C.show inventory
D.show platform
E.show version

最新試題

Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?()

題型:單項選擇題

If all OSPF routers in a single area are configured with the same priority value,what value dose a router use for the ODPF router ID in the absence of a loopback interface?()

題型:單項選擇題

An employee of ABC company has move to an office on a different floor. Although the administrator is able to telnet to all of the routers,the address of Switch F is needed in order to verify that the employee remains in the same VLAN.Which action could be used by the administrator to find the IP address of Switch F?()

題型:單項選擇題

Three switches are connected to one anther via trunk ports.Assuming the default switch configuration,which switch is elected as the root bridge for the spanning-tree instance of vlan 1?()

題型:單項選擇題

A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?()Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0

題型:單項選擇題

Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?()

題型:單項選擇題

Which device might be installed at a branch office to enable and manage an IPsec site-to-site VPN?()

題型:單項選擇題

Which command encrypts all plaintext passwords?()

題型:單項選擇題

What is the purpose of the cisco Vlan Trunking protocol?()

題型:單項選擇題

Which protocol reduces administrative overhead in a switched network by allowing the configuration of a new VLAN to be distributed to all the switches in a domain?()

題型:單項選擇題