Refer to the exhibit. R2 and R3 are routers connected using Ethernet services from a service provider and can receive pings from each other. OSPF is configured as the routing protocol but adjacency is not happening. According to the output of the show commands in the exhibit, what could be the most likely cause of the problem?（）
A.Ethernet interfaces were configured as point-to-point.
B.Process IDs are not matching.
C.Configured bandwidths do not match on both interfaces.
D.Broadcasts and multicast are not being propagated over the Ethernet services.
E.OSPF cost does not match on both interfaces.
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. You are setting up a 2-gigabit EtherChannel. Following IEEE standards, the exhibit shows your configuration in a local switch1. However, EtherChannel is not coming up. Which one of these statements could be a possible reason?（）
A.EtherChannel is only available in Cisco equipment.
B.The customer side is supposed to be running PAgP， which is a Cisco standard.
C.PAgP is not an IEEE standard. VRRP should be used.
D.The configuration on switch1 needs to be modified to use LACP.
A.RTP
B.RTSP
C.HTTP
D.TCP
E.UDP
最新試題
What is the three main step of using the QoS feature with MQC command line interface？
When upgrading the IOS image,the network administrator receives the exhibited error message.What could be the cause of this error?（）
As a CCNA candidate,you must have a firm understanding of the IPv6 address structure.Refer to IPv6 address,could you tell me how many bits are included in each filed?（）
what is the disadvantage of policing？
QoS機制中的分類，采用ip數據包中的哪個字段？
Refer to the exhibit.The network administrator is in acampus building distant from Building B.WANRouter is hosting a newly installed WAN link on interface S0/0.The new link is not functioning and the administrator needs to determine if the correct cable has been attached to the S0/0 interface.How can the administrator accurately verify the correct cable type on S0/0 in the most efficient manner?（）
The Frame Relay network in the diagram is not functioning properly.What is the cause of the problem?（）
問一個怎么樣的屬性，能讓路由不通告給任何的peer？
what is four ospf area type？
The following configuration line was added to router R1 Access-list 101 permit ip 10.25.30.00.0.0.255 any What is the effect of this access list configuration?（）