A.LDAP
B.ICMP
C.RTP
D.BGP
E.SSH
F.RDP
您可能感興趣的試卷
你可能感興趣的試題
A.When congestion is present，the priority command doesn’t allow exceeding the allocated rate
B.When congestion isn’t present，the priority command doesn’t allow exceeding the allocated rate
C.When congestion is present，the priority command allows exceeding the allocated rate
D.When congestion isn’t present，the priority command allows exceeding the allocated rate
A.qos-group
B.DSCP
C.LFI
D.NBAR
Refer to the exhibit. Router E learned about the PIM RP （designated as 7.7.7.7） from four different sources. Routers A and D advertised the 7.0.0.0 network via EIGRP. Routers B and C advertised the 7.0.0.0 network via OSPF. Considering that all four Ethernet interfaces on router E could potentially lead back to the PIM-RP， when router E receives the first multicast packet down the shared tree， which incoming interface will be used to successfully pass the RPF check？（）
A. E0
B. E1
C. E2
D. E3
E. None of these interfaces will be used to successfully pass the RPF check.
F. All of these interfaces would successfully pass the RPF check.
A.512 bits
B.768 bits
C.1024 bits
D.2048 bits
Refer to the exhibit. How would you get the 1.1.1.1 network into the OSPF database？ （）
A. Configure RTA as an ASBR
B. Redistribute connected routes on RTA into OSPF
C. Set up a virtual link between area 1 and area 0
D. Set up a virtual link between area 1 and area 2
E. Add a static route into RTB and enter it into OSPF
F. Place a network 1.1.1.0 0.0.0.0 command into RTB
G. Set up a unique router ID on RTA using an RFC 1918 address
H. Change area 0 on RTB to area 1
最新試題
How does an IPv6 router deal with a packet that is larger than the outgoing interface MTU？（）
Which of these statements about penultimate hop popping are true？（）
In order to configure two routers as anycast RPs， which of these requirements， af a minimum， must besatisfied？（）
Which two of these are used in the selection of a root bridge in a network utilizing Spanning Tree ProtocolIEEE 802.1 D？（）
Choose two commands that are required to enable multicast on a router， when it is known that thereceivers use a specific functionality of IGMPv3.（）
In GLBP，which router will answer on client ARP requests？（）
What is true about Unicast RPF in strict mode？（）
Two routers configured to run BGP have been connected to a firewall， one on the inside interface and one on the outside interface. BGP has been configured so the two routers should peer， including the correctBGP session endpoint addresses and the correct BGP session hop-count limit EBGP multihop. What is agood first test to see if BGP will work across the firewall？（）
Which two statements are true about RED？（）
Which multicast address is reserved for cisco-rp-discovery？（）