A.CEF
B.FIB
C.LFIB
D.IGP
您可能感興趣的試卷
你可能感興趣的試題
A.Be = 46320000 ，Bc = 96000
B.Be = 768000 ，Bc = 32000
C.Be = 128000 ，Bc = 7680
D.Be = 0 ，Bc = 96000
A.VRF
B.auto-summary
C.per-interface configuration
D.prefix-list support via route-map
E.prefix-list support via distribute-list
A.EIGRP for IPv6 is directly configured on the interfaces over which it runs.
B.EIGRP for IPv6 is not configured on the interfaces over which it runs， but if a user uses passive-interface configuration， EIGRP for IPv6 needs to be configured on the interface that is made passive.
C.There is a network statement configuration in EIGRP for IPv6， the same as for IPv4.
D.There is no network statement configuration in EIGRP for IPv6.
E.When a user uses a passive-interface configuration， EIGRP for IPv6 does not need to be configured on the interface that is made passive.
F.When a user uses a non-passive-interface configuration， EIGRP for IPv6 does not need to be configured on the interface that is made passive
A.anycast address
B.site-local multicast
C.global address of the link
D.unique local address
E.link-local address
A.IPv6 prefixes
B.link-local addresses
C.solicited node multicast addresses
D.IPv6 prefixes and topology information
最新試題
Refer to the exhibit.The network administrator is in acampus building distant from Building B.WANRouter is hosting a newly installed WAN link on interface S0/0.The new link is not functioning and the administrator needs to determine if the correct cable has been attached to the S0/0 interface.How can the administrator accurately verify the correct cable type on S0/0 in the most efficient manner?（）
What is method list for configure aaa？
SPT初始狀態之后的一個狀態是什么？
What is the next state of initial in spanning-tree protocol？
four switches， which one will be root switch.（no pic）.
Refer to the exhibit.What is the meaning of the term dynamic as displayed in the output of the show frame-relay map command shown？（）
What field in IP packet is used for classification by QOS？
A network administrator is troubleshooting the OSPF configuration of routers R1 and R2.The routers cannot establish an adjacency relationship on their common Ethernet link.The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2.Based on the information in the graphic,what is the cause of this problem?（）
How should arouter that is being used in a Frame Relay network be configured to avoid split horizon issues from preventing routing updates?（）
當將多個交換機加入到MST region當中會發生什么（what happen）？