多項選擇題Two switches are connected through a trunk link.which two commands show that there is a native VLAN mismatch on that link?()

A.show interfaces interface
B.show vlan bri
C.show interfaces interface switchport
D.show interface interface trunk
E.show interfaces vlan


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題

What is the most likely reason for the dispartly between the actual network numbers at the branches and the routes in the routing table on Gateway-Router?()

A.Branch-Router2 is configured to send both RIPv1 and RIPv2 updates.
B.Gateway-Router is configured to only receive RIPv2 updates.
C.Gateway-router is configured to receive only RIPv1 updates.
D.Branch-Router1 is configured to only send RIPv1 updates.

2.單項選擇題Which command is used to display the collection of OSPF link states?()

A.show ip ospf lsa database
B.show ip ospf link-state
C.show ip ospf neighbors
D.show ip ospf database

3.單項選擇題When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?()

A.show ip access-list
B.show access-list
C.list ip interface
D.show interface
E.show ip interface

4.多項選擇題

如圖,如果所有的鏈接都運行在相同的帶寬,哪些端口會被STP指定的端口?()

A. Switch A - Fa0/0
B. Switch A - Fa0/1
C. Switch B - Fa0/0
D. Switch B - Fa0/1
E. Switch C - Fa0/0
F. Switch C - Fa0/1

5.單項選擇題Three switches are connected to one anther via trunk ports.Assuming the default switch configuration,which switch is elected as the root bridge for the spanning-tree instance of vlan 1?()

A.the switch with the lowest MAC address
B.the switch with the higest MAC address
C.the switch witch the higest IP address
D.the switch with the lowest IP address

最新試題

請參見圖示。RouterB 已經過正確配置。RouterA 的以太網接口Fa0/0已使用如圖所示的命令進行配置。但是,從RouterA 的Fa0/0接口無法成功ping 通RouterB 的Fa0/0接口。應在RouterA 上采取什么措施來解決此問題?()

題型:?jiǎn)雾?xiàng)選擇題

請參見圖示。主機A 嘗試與主機C 建立TCP/IP 會話。在嘗試期間,路由器Y 的FastEthernet 接口fa0/1捕獲到一個幀。捕獲的幀中包含源IP 地址為172.16.1.5而目的IP 地址為172.16.7.24的數據包。捕獲該幀時,它的源MAC 地址是什么?()

題型:?jiǎn)雾?xiàng)選擇題

PC 無法連接到任何遠程網站,無法ping 通其默認網關,也無法ping 通本地網段中工作正常的打印機。以下哪項操作可以確認此PC 上的TCP/IP 協議棧是否工作正常?()

題型:?jiǎn)雾?xiàng)選擇題

請參見圖示。主機A 和B 無法互相通信。此問題的原因是什么?()

題型:?jiǎn)雾?xiàng)選擇題

請參見圖示。公司路由器由于故障被更換。更換路由器之后,Education 辦公室內的主機C 和D 能夠相互ping 通,但是無法訪問Accounts 辦公室內的主機。此問題的原因可能是什么?()

題型:?jiǎn)雾?xiàng)選擇題

請參見圖示。電纜1和電纜2分別按照特定的物理層要求接線。哪三個網段使用電纜2?()

題型:多項選擇題

在路由器上使用Router#copy running-config startup-config 命令會產生什么效果?()

題型:?jiǎn)雾?xiàng)選擇題

請參見圖示。當計算機A 向計算機D 發送幀時,哪些計算機會接收該幀?()

題型:?jiǎn)雾?xiàng)選擇題

何時必須使用clock rate 命令配置路由器串行接口?()

題型:?jiǎn)雾?xiàng)選擇題

請參見圖示。網絡技術人員試圖確定主機A 的正確IP 地址配置。以下哪一項是主機A 的有效配置?()

題型:?jiǎn)雾?xiàng)選擇題