After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?（）

What is the purpose of the cisco Vlan Trunking protocol?（）

On which options are standard access list based?（）

A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?（）Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0

The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?（）

Which name describes an IPV6 host-enable tunneling technique that uses IPV4 UDP,does not require dedicated gateway tunnels,and can pass through existing IPV4 NAT gateways?（）

What is the subnetwork address for a host with the IP address 201.100.5.68/28?（）

At which layer of the OSI model is RSTP used to prevent loops?（）

Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?（）

Which IPsec security protocol should be used when confidentiality is required?（）