單項選擇題A default Frame Relay WAN is classified as what type of physical network?()

A.point-to-point  
B.broadcast multi-access  
C.nonbroadcast multi-access  
D.nonbroadcast multipoint 
E.broadcast point-to-multipoint 


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題Which command displays the CHAP authentication process as it occurs between two routers?()

A. debug authentication
B. debug chap ppp
C. debug chap authentication
D. debug ppp authentication

2.單項選擇題At which layer of the OSI model dose PPP perform?()

A. Layer 3
B. Layer 4
C. Layer 2
D. Layer 5

3.單項選擇題After the show ip route command has been entered,the follwing routes are displayed.Which route will not be entered into the routing table of a neighboring router?()

A. R 192.168.8.0/24 [120/1] via 192.168.2.2, 00:00:10, Serial0
B. R 192.168.11.0/24 [120/7] via 192.168.9.1, 00:00:03, Serial1
C. C 192.168.1.0/24 is directly connected, Ethernet 0
D. R 192.168.5.0/24 [120/15] via 192.168.2.2,00:00:10,Serial0

4.單項選擇題Which encapsulation type is a Frame Relay encapsulation type that is supported by Cisco routers?()

A. IETF
B. HDLC
C. Q9333-A Annex A
D. ANSI Annex D

6.單項選擇題Which Cisco IOS diagnostics command can disrupt the operation of a router under high-load conditions?()

A. show running-config
B. show processes cpu
C. debug all
D. logging host ip address

7.單項選擇題At which layer of the OSI model is RSTP used to prevent loops?()

A. data link
B. network
C. physical
D. transport

8.單項選擇題A network administrator needs to configure a serial link between the main office and a remote location.The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?()

A. Main(config)#interface serial 0/0  Main(config-if)#ip address 172.16.1.1 255.255.255.252  Main(config-if)#no shut
B. Main(config)#interface serial 0/0  Main(config-if)#ip address 172.16.1.1 255.255.255.252  Main(config-if)#encapsulation ietf Main(config-if)#no shut
C. Main(config)#interface serial 0/0  Main(config-if)#ip address 172.16.1.1 255.255.255.252  Main(config-if)#encapsulation frame-relay  Main(config-if)#authenication chap Main(config-if)#no shut
D. Main(config)#interface serial 0/0  Main(config-if)#ip address 172.16.1.1 255.255.255.252   Main(config-if)#encapsulation ppp Main(config-if)#no shut

10.單項選擇題Which statement describes the rule of split horizon?()

A. Only router can split boundaries(horizons)between concentric networks.
B. All distance vector protocols require fall routes that may cause momentary loops as the topology changes.
C. Networks can only remain fully converged if all information about routes is sent out all active interfaces.
D. Information about a route should not be sent back in the direction from which the original update came.
E. Each AS must keep routing tables converged to prevent dead routes from being advertised across the AS boundary.

最新試題

The network administrator cannot to switch 1 over a telnet session,although the hosts attached to switch 1 can ping the interface Fa0/0 of the router.Given the information in the graphic and assuming that the router and switch2 are configured properly,which of the following commands should be issued on switch 1 to correct this problem?()

題型:?jiǎn)雾?xiàng)選擇題

While troubleshooting a network problem,a technician discovers that the current copy of the Cisco IOS is outdated and needs to be updated.Which of the following commands would the technician issue to replace the Cisco router IOS with the newer version?()

題型:?jiǎn)雾?xiàng)選擇題

An employee of ABC company has move to an office on a different floor. Although the administrator is able to telnet to all of the routers,the address of Switch F is needed in order to verify that the employee remains in the same VLAN.Which action could be used by the administrator to find the IP address of Switch F?()

題型:?jiǎn)雾?xiàng)選擇題

Which command encrypts all plaintext passwords?()

題型:?jiǎn)雾?xiàng)選擇題

A network administrator is trying to add a new router into an established OSPF network.The networks attached to the new router do not appear in the routing tables of the other OSPF routers.Given the information in the partial configuration shown below,what configuration error is causing this problem?()Router(config)#router ospf 1Router(config-router)#network 10.0.0.0 255.0.0.0 area 0

題型:?jiǎn)雾?xiàng)選擇題

Which command is used to display the collection of OSPF link states?()

題型:?jiǎn)雾?xiàng)選擇題

Which cisco ios command can help to determine the timing of various debug events,relative to each other,when you are debugging a complicated router issue?()

題型:?jiǎn)雾?xiàng)選擇題

What is the purpose of the cisco Vlan Trunking protocol?()

題型:?jiǎn)雾?xiàng)選擇題

A router receives information about network 192.168.10.0/24 from multiple sources.What will the router consider the most reliable information about the path to that network?()

題型:?jiǎn)雾?xiàng)選擇題

How are VTP advertisements delivered to switches across the network?()

題型:?jiǎn)雾?xiàng)選擇題