單項選擇題Which command enables RSTP on a switch?()

A.spanning-tree mode rapid-pvst
B.spanning-tree uplinkfast
C.spanning-tree backbonefast
D.spanning-tree mode mst


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題Why would a network administrator configure port security on a switch()。

A.to prevent unauthorized Telnet access to a switch port
B.to limit the number of Layer 2 broadcasts on a particular switch port
C.to prevent unauthorized hosts from accessing the LAN
D.to protect the IP and MAC address of the switch and associated ports
E.to block unauthorized access to the switch management interfaces over common TCP ports

2.單項選擇題Hosts on the same VLAN can communicate with each other but are unable to communicate with hosts on different VLANs. What is needed to allow communication between VLANs()。

A.a switch with a trunk link that is configured between the switches
B.a router with an IP address on the physical interface that is connected to the switch
C.a switch with an access link that is configured between the switches
D.a router with subinterfaces configured on the physical interface that is connected to the switch

3.單項選擇題There are no boot system commands in a router configuration in NVRAM.What is the fall back sequence that router will use to find an ios during reload?()

A.Flash,TFTPserver,ROM
B.Flash,NVRAM,ROM
C.ROM,NVRAM,TFTPserver
D.NVRAM,TFTPserver,ROM
E.TFTPserver,F(xiàn)lash,NVRAM

4.單項選擇題

根據下圖,Switch1剛剛完成重啟,并完成上電自檢。HostA發送它的第一個偵到HostC,交換機首先會對switching table做什么操作()

A.Switch1會添加192.168.23.4到switchingtable
B.Switch1添加192.168.23.12到switchingtable
C.Switch1添加000A 8A47.E612到switchingtable
D.Switch1添加000B DB95.2EE9到switchingtable

5.單項選擇題哪種擴頻技術是802.11B定義使用的?()

A.IR
B.DSSS
C.FHSS
D.DSSS and FHSS
E.IR,F(xiàn)HSS,and DSSS

最新試題

請參見圖示。電纜1和電纜2分別按照特定的物理層要求接線。哪三個網段使用電纜2?()

題型:多項選擇題

請參見圖示。網絡技術人員使用圖中所示的連接將主機A 連接到路由器以創建初始配置。下列有關此連接的陳述中哪一項正確?()

題型:單項選擇題

請參見圖示。主機B 嘗試與主機C 建立TCP/IP 會話。在嘗試期間,San Francisco 器由器的FastEthernet 接口fa0/1捕獲到一個幀。捕獲的幀中包含源IP 地址為10.10.1.2而目的IP 地址為10.31.1.20的數據包。捕獲該幀時,它的目的MAC 地址是什么?()

題型:單項選擇題

何時必須使用clock rate 命令配置路由器串行接口?()

題型:單項選擇題

傳輸層如何讓主機能同時針對不同應用程序維護多個通信流?()

題型:單項選擇題

請參見圖示。RouterB 已經過正確配置。RouterA 的以太網接口Fa0/0已使用如圖所示的命令進行配置。但是,從RouterA 的Fa0/0接口無法成功ping 通RouterB 的Fa0/0接口。應在RouterA 上采取什么措施來解決此問題?()

題型:單項選擇題

下列哪些是私有IP 地址的地址范圍?()

題型:多項選擇題

請參見圖示。網絡中的所有設備均使用默認配置。此拓撲中存在多少個廣播域?()

題型:單項選擇題

在Cisco IOS 設備中,啟動配置文件存儲于何處?()

題型:單項選擇題

請參見圖示。主機A 嘗試與主機C 建立TCP/IP 會話。在嘗試期間,路由器Y 的FastEthernet 接口fa0/1捕獲到一個幀。捕獲的幀中包含源IP 地址為172.16.1.5而目的IP 地址為172.16.7.24的數據包。捕獲該幀時,它的源MAC 地址是什么?()

題型:單項選擇題