A.gravity separation
B.centrifuge
C.Cyclone
D.Cross-flow membrane filtration
您可能感興趣的試卷
你可能感興趣的試題
A.The requirement for the oil content of bilge water discharged is 15 ppm
B.No discharge in sensitive waters
C.Any discharge in sensitive waters
D.International, national or local requirements have to be observed
A.The high temperature facilitates primary gravity separation
B.Most of the oil and organic solvents are raised to the top layer
C.The high the temperature is, the more the top oil will be collected
D.The high temperature has little use on the separation of emulsified oil
A.Oil leaking from tanks inside engine room
B.Engine room cleaning water
C.Water leaking from the separator sludge tank
D.Sewage
A.reclaims water
B.purges air without losing refrigerant
C.purges air with some loss of refrigerant
D.purges lube oil from the refrigerant
A.re-evaporator
B.receiver
C.dehydrator
D.solenoid
最新試題
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?（）
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?（）
During the diesel engine running, the water level of F.W expansion tank should normally kept in the （） level of glass tube.
The ISPS Code consists of a mandatory section-Part A, which shows（）
（） is not installed on the main switchboar.
If two A.C.generators are to be operated in parallel, the load is distributed evenly by（）
Which of the diesel engine components listed increase air density and helps to improve engine operating efficiency?（）
The main purpose of port State control is not to（）
The treatment of the fuel oils involves storage, heating, filtering and（）
To shut down a diesel engine after it exceeds the set maximum speed，which type of device listed should be used?（）