A.to increase the system efficiency by sensible heat transfer
B.to stop the liquid from flashing
C.to reduce the load on the compressor
D.to remove latent heat of vaporization and the suction piping transfer
您可能感興趣的試卷
你可能感興趣的試題
A.its pressure and temperature are both lowered
B.its pressure and temperature are both raised
C.its pressure is lowered and its temperature is raised
D.its pressure is raised and its temperature is lowered
A.thermal valve
B.magnetic stop valve
C.bellows valve
D.bimetallic valve
A.high-pressure cutout switch is jammed open
B.low-pressure switch is jammed shut
C.thermal bulb is not operating properly
D.scale trap is clogged
A.in the middle of evaporator coils
B.near the evaporator coil outlet
C.near the evaporator coil inlet
D.on the bottom row of evaporator coils
A.amount of superheat in the vapor leaving the coil
B.amount of superheat in the liquid
C.temperature in the evaporator coils
D.pressure in the evaporator coils
最新試題
Flame failure in an automatically fired auxiliary boiler can from a/an （）
Which of the listed governor characteristics will greatly affect the load sharing relationship between paralleled diesel generators?（）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
Diesel engine air start system check valves are opened by （）
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is（）
（） is not installed on the main switchboar.
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?（）
Engine parameters shall be corresponded to NOx Technical Files. This is required by （）
Which of the diesel engine components listed increase air density and helps to improve engine operating efficiency?（）
During the diesel engine running, the water level of F.W expansion tank should normally kept in the （） level of glass tube.