When does auxiliary burner of incinerator put into operation? （）
Ⅰ.tart incinerator when it is cold
Ⅱ.he sludge for dealing with is little
Ⅲ.he sludge for dealing with is large
Ⅳ.he water and impurity in sludge are too much
Ⅴ.he temperature in incinerator is low
Ⅵ.ealing with little solid rubbish
A.Ⅰ+Ⅱ+Ⅲ+Ⅴ
B.Ⅰ+Ⅱ+Ⅲ+Ⅳ
C.Ⅰ+Ⅳ+Ⅴ+Ⅵ
D.Ⅰ+Ⅱ+Ⅲ+Ⅵ
您可能感興趣的試卷
你可能感興趣的試題
A.filled with clean water before operation
B.keep air cushion in oil collecting space during running
C.check oil level during running
D.clean inner separator with low pressure stream
A.pay attention to operating parameters
B.renew and clean separating units in time
C.check oil level in separator to prevent overload
D.check separating effect, if it is bad, flush with large capacity water pump
A.overhauling every two year
B.working at intervals
C.renewing filtration material
D.pumping bilge water from different layers respectively
A.working at intervals and properly heating
B.warming up to 70℃, increase water supply flow
C.improving impulse of water supply
D.reducing water supply flow
A.flushing separator with hot water
B.increasing water supply flow
C.heat oily water properly
D.opening manual oil discharge value
最新試題
Diesel engine air start system check valves are opened by （）
The Port State Control officer may witness a fire drill carried out by the crew assigned to these duties on the（）
The condensers located in various stages of a flash evaporator are cooled by（）
For a given exhaust gas boiler, what is the quantity of its evaporation mainly determined?（）
（） is not installed on the main switchboar.
If separating effect is not good, which measure should be taken （）
Flame failure in an automatically fired auxiliary boiler can from a/an （）
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?（）
Engine parameters shall be corresponded to NOx Technical Files. This is required by （）
The main purpose of port State control is not to（）