A.compensate for major leaks in the system
B.maintain the original fluid viscosity
C.allow for changes in pressure and temperature within the system
D.assure constant fluid temperature
您可能感興趣的試卷
你可能感興趣的試題
A.ground the board
B.avoid reversing the polarity of the leads
C.isolate sensitive components with heat sinks
D.all of the above
A.vaporize, with the unflashed water remaining at the temperature at which it entered the flash chamber
B.vaporize, with the unflashed water equalizing to the saturation conditions existing in the flash chamber
C.vaporize, with the remaining water at the temperature greater than it entered the flash chamber
D.boil, allowing steam bubbles to rise through the brine at the bottom of the flash chamber
A.The solenoid valves directs high pressure gas to the valve lifting device raising the suction valve off its seat and causing one specific cylinder to become unloaded
B.The solenoid valves directs high pressure gas to the underside of the unloading piston, causing it to rise and allowing the recirculating ports to be opened
C.When the solenoid valve becomes energized, the valve ports become closed, allowing discharge pressure to build up above the piston, shifting it and causing it to unload
D.The solenoid valve allows the refrigerant to pass from the suction chamber to the top of the unloader piston, causing the piston to lift and unload the cylinder
A.pressure does not fluctuate rapidly
B.pressure remains steady and unchanged
C.brine density does not exceed 1~5
D.brine density is too low
A.moisture emulsification of the bearing grease
B.insufficient circulation and overheating of the bearing
C.proper grease circulation to cool the bearing
D.sliding friction between balls and races
最新試題
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is（）
（）connectors hold best if a wire is accidentally pulled or a connection becomes loose.
Diesel engine air start system check valves are opened by （）
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the（）
Which of the diesel engine components listed increase air density and helps to improve engine operating efficiency?（）
The condensers located in various stages of a flash evaporator are cooled by（）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
The additional mark （）in the Classification Certificate for Machinery means propulsion apparatus is remotely controlled on the navigating bridge control station, and engine assembly control station is unmanned periodically.
Flame failure in an automatically fired auxiliary boiler can from a/an （）
“Insufficiency of manning or insufficiency of certification of seafarers” is an identification of a（）