A.excessive fuel pressure
B.high lube oil viscosity
C.inadequate fuel injection
D.excessive starting air pressure
您可能感興趣的試卷
你可能感興趣的試題
A.proper break-in wear
B.improper break-in wear
C.relocation of the overlay flashing
D.water contamination of the lube oil system
A.water in the fuel
B.cold lube oil
C.excessive starting air pressure
D.excessive fuel pressure
A.fuel pump should be removed and all connections blanked off
B.cylinder oil feed rate should be increased slightly above that used at normal sea speed
C.cylinder oil feed rate should be reduced
D.cylinder oil feed rate should be increased to the maximum flow capable of the metering pump
A.the proper back pressure
B.the cooling water temperature
C.correct timing and proper seating
D.accurate metering and the exhaust temperature
A.low exhaust back pressure
B.air in the fuel system
C.gasket blow-by or leakage
D.incorrect assembly of idler springs
最新試題
The main purpose of port State control is not to（）
（）connectors hold best if a wire is accidentally pulled or a connection becomes loose.
Which of the diesel engine components listed increase air density and helps to improve engine operating efficiency?（）
The Port State Control officer may witness a fire drill carried out by the crew assigned to these duties on the（）
Engine parameters shall be corresponded to NOx Technical Files. This is required by （）
The cetane rating of diesel fuel is an indication of the （）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
During the diesel engine running, the water level of F.W expansion tank should normally kept in the （） level of glass tube.
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?（）