A.before TDC and close after BDC
B.after TDC and close after BDC
C.before TDC and close before BDC
D.after TDC and close before BDC
您可能感興趣的試卷
你可能感興趣的試題
A.an air start cam
B.cylinder compression pressure
C.starting air pressure
D.valve springs
A.chemical analysis
B.back pressure readings
C.pyrometer readings
D.infrared analysis
A.insufficient fuel supply due to fuel pump valves sticking or leaking
B.excessive mechanical clearance between the piston crown and cylinder head
C.excessively worn fuel pump plunger
D.excessive exhaust back pressure
A.detecting faulty combustion in individual cylinders
B.adjusting fuel racks to maintain equal loading between cylinders
C.adjusting the load limit setting of the governor at idle conditions
D.calculating engine horsepower
A.tension load twice each crankshaft revolution
B.compression load during power and compression strokes
C.inertia load once every four crankshaft revolutions
D.bending loads at bottom and top dead center
最新試題
A purge recovery system is used in a centrifugal air conditioning or refrigeration system to （）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
During the diesel engine running, the water level of F.W expansion tank should normally kept in the （） level of glass tube.
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is（）
Using a file without a handle may result in （）
（）connectors hold best if a wire is accidentally pulled or a connection becomes loose.
The condensers located in various stages of a flash evaporator are cooled by（）
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated（）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
To shut down a diesel engine after it exceeds the set maximum speed，which type of device listed should be used?（）