A.starting the engine hot
B.knurling the piston skirt
C.operating an overheated engine
D.using scuff resistant piston rings
您可能感興趣的試卷
你可能感興趣的試題
A.the amount of lube oil additives increase
B.piston speeds increase
C.injection pressure decrease
D.engine speeds decrease
A.less piston slap and quieter running
B.increased crankshaft bearing wear
C.slightly greater piston wear
D.decreased side pressures
A.Liner wear is distributed equally between the upper and lower portions of the cylinder
B.Excessive liner wear causes wear between piston ring and groove
C.Excessive, but uniform liner wear will not cause wear between piston ring and groove
D.Liner wear is normally greatest in the middle of the cylinder
A.alternation of side thrust
B.a breakdown of the lube oil film on the cylinder wall
C.worn piston boss piston pin bearings
D.fluctuating gas pressure in the combustion space
A.hard starting
B.excessive fuel consumption
C.loss of power
D.all of the above
最新試題
The condensers located in various stages of a flash evaporator are cooled by()
Thermostatic steam pressure reducing valves are used in the fuel oil service system to control the()
Which one is NOT the ‘clear grounds’ for a more detailed inspection?()
A purge recovery system is used in a centrifugal air conditioning or refrigeration system to ()
Engine parameters shall be corresponded to NOx Technical Files. This is required by ()
Which of the listed governor characteristics will greatly affect the load sharing relationship between paralleled diesel generators?()
When does auxiliary burner of incinerator put into operation? ()Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
Under MARPOL Code the ship to which it applies has to carry ()
Refrigerant entering the compressor of a refrigeration system should be in which of the following conditions?()
If separating effect is not good, which measure should be taken ()