A.To prevent internal damage form local overheating
B.To ensure the fuel nozzles are flushed clean
C.To clear the smoke stack
D.To let the waste heat boiler reduce its rate of steam generation
您可能感興趣的試卷
你可能感興趣的試題
A.loss of power
B.misfiring
C.low fuel oil pressure
D.All of the above
A.Increase the cooling water flow to the engine
B.Secure or reduce fuel to that cylinder
C.Screw down on the pressure adjusting spring to decrease to decrease popping pressure
D.Readjust the injection timing
A.The greater the atomization, the greater the penetration
B.The greater the atomization, the less the penetration
C.The degree of atomization has nothing to do with the degree of penetration
D.Atomization and penetration are one and the same
A.Move the fuel control mechanism to the no fuel position
B.Block the fuel supply by closing the master fuel valve
C.Shut off the fuel supply and block the flow of intake air
D.Relieve all pressure in the fuel system
A.airification
B.vaporization
C.atomization
D.gasification
最新試題
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
The ISPS Code consists of a mandatory section-Part A, which shows（）
The treatment of the fuel oils involves storage, heating, filtering and（）
If separating effect is not good, which measure should be taken （）
The main purpose of port State control is not to（）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
Which one is NOT the ‘clear grounds’ for a more detailed inspection?（）
The cetane rating of diesel fuel is an indication of the （）
To proceed to the assistance of a ship in distress is（）
The additional mark （）in the Classification Certificate for Machinery means propulsion apparatus is remotely controlled on the navigating bridge control station, and engine assembly control station is unmanned periodically.