A.current in the circuit
B.voltage in the circuit
C.inductance in the circuit
D.resistance in the circuit
您可能感興趣的試卷
你可能感興趣的試題
A.opposes any change in the applied voltage
B.opposes any change in the current flow through the circuit
C.aids any changes in the applied voltage
D.aids any changes in the current through the circuit
A.low loads necessitate frequent insulation cleaning
B.exceeding nameplate values shortens useful life
C.energy is wasted if full loading is not utilized
D.power factor correction methods are load dependent
A.The generator and bus transfer section
B.The 450 volt, 60 cycle, 3 phase bus
C.The 120 volt, 3 phase, 60 cycle bus
D.The 24 volt DC bus
A.increases as the square of the current
B.decreases as the square root of the current
C.remains the same, as it is independent of current flow
D.increases in direct proportion as the current
A.1 volt, the output changes 5 volts
B.5 volts, the output changes 1 volt
C.5 volts, the output changes 10 volts
D.10 volts, the output changes 5 volts
最新試題
The cetane rating of diesel fuel is an indication of the ()
One of the reasons that cause oil flowed from sludge outlet of a self-cleaning separator is()
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a()
The ISPS Code consists of a mandatory section-Part A, which shows()
When does auxiliary burner of incinerator put into operation? ()Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
To shut down a diesel engine after it exceeds the set maximum speed,which type of device listed should be used?()
Using a file without a handle may result in ()
()connectors hold best if a wire is accidentally pulled or a connection becomes loose.
The flash point of a residual fuel oil should be used to determine the highest temperature to which oil may be heated()
The main purpose of port State control is not to()