A.copper and antimony
B.steel and babbitt
C.aluminum or beryllium alloy
D.zinc or an alloy of tin and lead
您可能感興趣的試卷
你可能感興趣的試題
A.prevent grounds in branch circuits
B.prevent opens in motor circuits
C.permit momentary overloads without melting
D.guard lighting and electronic circuits
A.Each has three separate but identical armature windings acted on by one system of rotating magnets
B.Each has one armature winding acted on by three identical but separate systems of rotating magnets
C.All three-phase alternators are designed to operate with a O8 leading power factor
D.The three phases always provide power to the load through three sets of slip rings and brushes
A.eliminate slippage
B.provide excitation
C.provide starting torque
D.increase efficiency
A.wash it with fresh water and apply an external source of heat
B.renew the windings
C.send it ashore to an approved service facility
D.rinse all electrical parts with a carbon tetrachloride cleaning solvent and then blow dry the motor with compressed air
A.the recommended current and voltage rating
B.higher current and voltage rating
C.higher current and lower voltage rating
D.lower current and higher voltage rating
![](https://static.ppkao.com/ppmg/img/appqrcode.png)
最新試題
If two A.C.generators are to be operated in parallel, the load is distributed evenly by()
As soon as a diesel engine has started, which of the listed engine operating parameters should be checked FIRST?()
The ISPS Code consists of a mandatory section-Part A, which shows()
Flame failure in an automatically fired auxiliary boiler can from a/an ()
“Insufficiency of manning or insufficiency of certification of seafarers” is an identification of a()
The condensers located in various stages of a flash evaporator are cooled by()
()connectors hold best if a wire is accidentally pulled or a connection becomes loose.
To shut down a diesel engine after it exceeds the set maximum speed,which type of device listed should be used?()
Which one is NOT the ‘clear grounds’ for a more detailed inspection?()
If separating effect is not good, which measure should be taken ()