A.draw a one line diagram of the circuitry
B.test all fuses and measure the line voltage
C.take megger readings
D.insulate the apparatus from ground
您可能感興趣的試卷
你可能感興趣的試題
A.melts and must be replaced
B.is enclosed in a tube of insulating material with metal ferrules at each end
C.gives no visual indication of having opened the circuit
D.trips to break the circuit and may be reset
A.brushes on a commutator
B.brushes on slip rings
C.slip rings on a commutator
D.direct connections from the stator
A.heat-resisting acrylic
B.heat-resisting aluminum
C.insulating varnish
D.insulating white lead
A.hydrogen chloride
B.calcium chloride
C.sulfuric acid
D.muriatic acid
A.can be reset to energize the circuit
B.should open the circuit when overloaded
C.will burn out when an over current flow develops
D.All of the above
最新試題
If two A.C.generators are to be operated in parallel, the load is distributed evenly by（）
（） is not installed on the main switchboar.
Flame failure in an automatically fired auxiliary boiler can from a/an （）
To proceed to the assistance of a ship in distress is（）
By comparing the exhaust gas temperature of each cylinder, the operator can determine if the load is balanced throughout the engine. The device most commonly used is a（）
“Insufficiency of manning or insufficiency of certification of seafarers” is an identification of a（）
When does auxiliary burner of incinerator put into operation? （）Ⅰ. start incinerator when it is coldⅡ. the sludge for dealing with is littleⅢ. the sludge for dealing with is largeⅣ. the water and impurity in sludge are too muchⅤ. the temperature in incinerator is lowⅥ. dealing with little solid rubbish
If separating effect is not good, which measure should be taken （）
The main purpose of port State control is not to（）
The treatment of the fuel oils involves storage, heating, filtering and（）