A.Cross
B.Parallel
C.Counter
D.Circular
您可能感興趣的試卷
你可能感興趣的試題
A.remain constant along the tubes length
B.be greatest in a single pass counter flow heat exchanger
C.remain constant throughout the heat exchanger
D.vary from section to section through out the heat exchanger
A.a low load on the unit
B.a clogged pump suction strainer
C.a blockage in the line between the pump and hydraulic motor
D.the hydraulic motor turning too fast
A.cause of salt contamination
B.location of salt water contamination
C.chemical makeup of feed-water
D.level of alkalinity in condensate
A.refrigerant overcharge
B.overfeeding by the expansion valve
C.a restricted suction strainer
D.due to short cycling of the compressor
A.capacity will increase
B.capacity will decrease
C.suction pressure will increase
D.suction pressure will decrease
最新試題
Thermostatic expansion valves can be adjusted for （）.
The amount of fluid friction or internal friction inherent in a mineral lubricating oil is reflected as a measure of its （）.
If the suction pressure at the refrigeration compressor is below normal, the cause can be（）.
The rate of heat transfer between the hot and cold fluids passing through a shell-and-tube type heat exchanger will （）.
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by （）.
Who is responsible for ensuring that someone is assigned to close the watertight doors in an emergency?（）
Heavy wear in a particular area of the inner circumference of a packing ring may be caused by （）.
A pressure drop through the refrigerant liquid line may cause （）.
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should （）.
The major source of chemical contaminants in hydraulic fluid is （）.