A.add refrigerant to the system
B.adjust the thermal expansion valve to the proper setting
C.adjust the float valve to the proper holding pressure
D.open the hand expansion valve
您可能感興趣的試卷
你可能感興趣的試題
A.a stuck solenoid valve
B.a shortage of refrigerant
C.too much oil in circulation
D.too much superheat
A.trick-wheel
B.follow-up control
C.six-way valve
D.Rapson slide
A.stress
B.strain
C.shear strength
D.ultimate tensile strength
A.increase discharge pressure
B.decrease pump capacity
C.decrease pump cavitation
D.decrease reaction ring clearance
A.too much superheat
B.insufficient superheat
C.suction pressure too low
D.excessive refrigerant returning to the compressor
最新試題
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should （）.
If the suction pressure at the refrigeration compressor is below normal, the cause can be（）.
Heavy wear in a particular area of the inner circumference of a packing ring may be caused by （）.
A salinity indicator is used to determine the （）.
Thermostatic expansion valves can be adjusted for （）.
If the thermal bulb of an expansion valve is incorrectly placed at the center of the coil instead of the end, it will （）.
Pitting in the suction areas of a centrifugal pump bronze impeller is usually caused by （）.
Which of the following problems could cause the high pressure cutout switch to shut down the compressor in a refrigeration system?（）
An excessive charge of refrigerant in an air-cooled refrigeration system can cause （）.
When the steering gear is in operation, you should （）.