A.trick wheel
B.accumulator
C.standby pump
D.telemotor
您可能感興趣的試卷
你可能感興趣的試題
A.Open the bilge pump for inspection
B.Remove each of the manifold valves
C.Remove only the manifold valve to the affected bilge-well
D.Attempt to pump out another bilge well to determine if the entire system is affected
A.too much refrigerant in the system
B.oil entrained in the refrigerant
C.less than a full charge of refrigerant in the system
D.ice crystals forming in the refrigerant
A.with both pumps on line at the same time
B.with one pump on standby
C.with the follow-up gear disconnected
D.only when the rudder is moved amidships
A.high temperature distillate can be re- circulated to induce additional flashing
B.scale formation is not a severe problem
C.cold shocking is more effective in removing scale
D.water purity is greatly increased at high capacity
A.high pressure liquid line
B.low pressure liquid line
C.high pressure vapor line
D.low pressure vapor line
最新試題
A gradual decrease in the discharge pressure of an operating hydraulic pump can be caused by ().
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by ().
The usual symptoms of cavitation in a centrifugal pump is ().
Heavy wear in a particular area of the inner circumference of a packing ring may be caused by ().
The amount of fluid friction or internal friction inherent in a mineral lubricating oil is reflected as a measure of its ().
If the viscosity of the liquid being transferred remains constant as the discharge pressure increases, the rotary pump ().
The rate of heat transfer from a hot region to a cold region is affected most by the ().
Thermostatic expansion valves can be adjusted for ().
If the thermal bulb of an expansion valve is incorrectly placed at the center of the coil instead of the end, it will ().
Which of the following statements is correct concerning heat transfer?()