A.Liquids with different viscosities will always have the same specific gravity
B.Liquids with different viscosities will never have the same specific gravity
C.Viscosity and specific gravity are directly proportional
D.Viscosity and specific gravity are not related in that one does not define or limit the other
您可能感興趣的試卷
你可能感興趣的試題
A.stored at temperatures below 60 degrees Fahrenheit
B.charged into a system having copper fittings
C.allowed to mix with compressor oil
D.exposed to an open flame or hot surface
A.acid formation
B.sludge formation
C.ice in the expansion valve
D.All of the above
A.superheated outside the system
B.in contact with an open flame
C.heated to the boiling point
D.All of the above
A.Variable volumes can be obtained with gear pumps only by variation of the pump drive speed
B.A radial piston pump houses sliding pistons in a stationary cylinder block through which passes a rotating pintle or ported shaft
C.The amount of fluid displaced per revolution of an axial piston rotary pump is dependent on the angle formed between the cylinder block and valve plate
D.All of the above
A.transmit the rudder angle to the bridge indicator
B.prevent the control linkage from striking the stops when hard over
C.automatically purge all entrained air from the system
D.send hydraulic signals to the receiving unit
最新試題
Thermostatic expansion valves can be adjusted for ().
Which of the following statements is correct concerning heat transfer?()
An increasing head pressure in a refrigeration system, without any corresponding change in the cooling water inlet temperature, would probably be caused by ().
One cause of high head pressure occurring in a refrigeration system can be ().
A salinity indicator is used to determine the ().
Low compressor head pressure in a refrigeration system can be caused by().
A salinity indicator is used to determine the ().
If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be ().
The output volume of a positive fixed displacement pump can be changed only by ().
If the thermal bulb of an expansion valve is incorrectly placed at the center of the coil instead of the end, it will ().