A.superheated outside the system
B.in contact with an open flame
C.heated to the boiling point
D.All of the above
您可能感興趣的試卷
你可能感興趣的試題
A.Variable volumes can be obtained with gear pumps only by variation of the pump drive speed
B.A radial piston pump houses sliding pistons in a stationary cylinder block through which passes a rotating pintle or ported shaft
C.The amount of fluid displaced per revolution of an axial piston rotary pump is dependent on the angle formed between the cylinder block and valve plate
D.All of the above
A.transmit the rudder angle to the bridge indicator
B.prevent the control linkage from striking the stops when hard over
C.automatically purge all entrained air from the system
D.send hydraulic signals to the receiving unit
A.horizontally mounted
B.never fitted with intake filters
C.fitted with intercoolers
D.operated in an unloaded condition at all times
A.High pressure compressors are more efficient than low pressure compressors
B.Mechanical efficiency divided by compressor efficiency will equal the overall efficiency of the compressor unit
C.Two stage compressors are generally more efficient than single stage compressors
D.The volumetric efficiency is decreased in multistage compressors
A.precipitation number
B.neutralization number
C.pour point
D.demulsibility
最新試題
A pressure drop through the refrigerant liquid line may cause ().
A gradual decrease in the discharge pressure of an operating hydraulic pump can be caused by ().
If the head pressure of a reciprocating refrigeration compressor is excessive, ().
The general purpose of a heat exchanger is to ().
If you are given the job of adding hydraulic fluid to a mooring winch, and are not certain as to the type of fluid to use, you should ().
Which of the following problems could cause the high pressure cutout switch to shut down the compressor in a refrigeration system?()
When a refrigeration compressor has developed a high head pressure as a result of a refrigerant overcharge, you should ().
A salinity indicator is used to determine the ().
Heavy wear in a particular area of the inner circumference of a packing ring may be caused by ().
If the relief valve on the discharge side of a hydraulic pump lifts, the cause could be ().